Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools
Your Cart
Your shopping cart is empty!
Printer View Tell a Friend

Non-Penetrating Roof Mount 60" Mast with 1.25" O.D.

Price$131.00
Manufacturer CodeVMP-FRM125
Qty
AvailabilityUsually ships in 24 Hrs
ShippingCan ship Canada

Highlights

60" Mast
1.25" O.D.
Off-Air Antennas
Satellite Antennas
Comes with Hardware

Powder Coated

Bulk Quantities Available Here!

VMP FRM125 Non-Pen Roof Mount with 1.25" O.D. Mast 60" Length


is constructed of Powder Coated steel and uses standard concrete blocks to anchor on Flat Roof. Mast is 1.25 inches in Outside Diameter and 60 inches in Height from Base. For use with DBS, antenna and satellite internet systems. Can be Used as a Penetrating Mount without Ballast. Compares to Other Name Brand Hardware at Half the Price.
 
This Non-Penetrating Mount Series from VMP is finished with a dark brown weather resistant powder coat inside and out that blends well with residential environments. With the 5 foot long, 1.25 inch O.D. pipe, you can mount HD TV Off-air antennas to be sure. With the 1.66 to 1.25 inch reducers available, you can also mount as applicable; DISH Network dishes, including 18" round dish, DIRECTV Oval, DISH 500, DISH 1000, DISH 1000.1, or both the TV antenna and the Satellite Dish on the same mast (with appropriate clearance and within reason). And as with all items in this Product Line, Screws and Pitch Pads are included for Bolt-down versus Ballast applications. The Length of the mast is 5 feet based on engineering that incorporates consideration for typical TV or Small Satellite Antenna Wind-load versus the Ballast that would keep either on target with minimal deviation and flex. As with all Ballast mounts, Structural Engineering consultations are recommended for all Roof Applications.
Specification Sheet






Rate this product.
Product isn't rated yet. Write a review.

Flat Roof Non-Penetrating Mounts

These mounts can be used where penetrating its attachment is not an option. Non penetrating mounts use a balasest like your usual cement cinder block as a method to hold down your masting structure. They can help meet the variety of communication tower needs such as Cellular, PCS, Wireless Cable, Microwave, Wireless Internet, WiFi Hot Spots, DBS, MDS, MMDS and UHF/VHF reception.

Designed and engineered to handle the job of getting above ground interference, each non-penetrating roof mount has been researched and developed to serve a specific purpose.

With professionally engineered construction, you can be assured you're getting a virtually maintenance-free product built to the highest standards. And because our non-penetrating roof mounts are hot-dip galvanized after fabrication, our mounts won't rust.

    Additional Features Include
  • Offer both Fixed Mounts and Ballast Roof Mounts
  • Pre-Galvanized for corrosion protection
  • Varied mast heights available
  • Varied mast pipe O.D. available
  • Quickly shipped and quickly assembled
  • Minimum bolted connections
  • Engineering ballast tables available
  • Optional roof pads and mats available
  • All models are UPS shippable

Products   Recently Viewed