|
|
 |
Non-Penetrating Roof Mount Low Profile for Light Antennas |
|
|
|
Easy Up EZ NP Non-Penetrating Low Profile Roof Mount
Ideal for Light Off-Air TV and Wireless Internet Antenna mounting, is constructed of pre-galvanized steel, uses 6 standard concrete blocks to anchor, 29 x 35.5" base, accepts masts from 1.00 to 1.75 inch O.D...
For light antenna loads needing 10 feet in height, use this mount in combination with (2)EZ 5-16S swaged 1.25" O.D. masts, several EZ 50 turnbuckles, some 620 guy wire and the EZ 43-A Guy Ring! (available separately)
Also can be used as a non-pen base for an H20 or H30 Telescopic mast, though down guys will still be required as per Factory recommendations.
Availability:
Usually ships in 24 Hrs
Shipping:
Can ship anywhere
|
EZ46-3 Pitch Pad Kit with Screws
- $2.95
EZ 46-3 Pitch Pad Kit with Screws
Complete with (3) 3 x 1.5" Moisture Barrier Pitch Pads and (6) 2 x 1/4" Hex Head Integral Washer Lag Screws for Weather-Proof Bracket Mounting to Exterior Surfaces. Most popular screw size for the majority of Antenna Mast Bracket Installations..
Shipping/ More Info Here
|
Protective Rubber Mat Layer for Non-Penetrating Antenna Roof Mount
- $19.95
VMP FRM-MAT Satellite Dish Non-penetrating Roof Mount Rubber Protective Mat
A Protective Layer between the Roof Surface and the Non-Penetrating Roof Mount before Installation. This 3/32 thick Pad measures roughly 36 wide by 42 inches long, trims neatly, place underneath Frame of Non-Penetrating mount, on top of Roof surface...
Shipping/ More Info Here
|
|
|
|
|
|
|
There is no substitute of height, clear line-of-site and size does matter... The higher the frequency, the higher the loss... Amplifiers do not give you something that you didn't have already...
The first key to any reception is to get above obstructions that exist between you and your target, as radio frequency reception of any kind (satellite, microwave, Radio and TV) are for the most part "Line-of-Sight" dependant. The fact that some receptions occur without line of sight is due to phenomenon not applicable in this discussion. As you increase your target distance, you increase the territory you must account for in maintaining line-of-sight. What tall building and air traffic exist in this corridor, no one can account for. Aircraft are very good at messing up reception for a number of reasons, even when flying way above the path, again removed for clarity in this discussion. Height, is therefore key in optimizing your ability to capture the best line-of-sight possible to your target.
The Roof of any Building of Home provides a Logical Platform of Height in which Line-of-Sight is more likely to occur, or from which, more height can easily be obtained. These Mounts are Quality made by Manufacturers with a History in the Field of Proven Success and Longevity. Whether you are planning to Install your Antenna and Mount to the Roof Peak, Gable, Vent Pipe, Chimney or Pitch, Please plan your installation to Minimize the Structural and Asthetic Impact to your House or Building, research and follow all applicable Local Building Codes and annex the appropriate Structural Engineering Assistance when utilizing Non-Penetrating Mounts with Concrete Cinder Block Ballast on any Flat or Pitched Roof.
|
|
|
|
|
|
|
|
|
Your shopping cart is empty!
|
|
|
