Average Customer Rating: 
100% 0% (1 votes)
0% (1 votes)Found: 1
12 Mar 2020, 12:39 AM
Ken Wheeler (Guest)
Good tower
Could have went from good to excellent. The rocket top center tube had a large glob of weld preventing the mast to sit center.
I had to devise a extension with a support handle to reach down inside where the three support tubes are welded on in order to grind away the glob of weld, then I had to purchase a can of cold Galvanizing paint to re coat inside.
The center rocket top tube was not welded on straight, not parallel with the support tubes it was welded on.
Being dipped in galvanizing leaves some drips that harden into tiny sharp points, one needs to go over each section and using side cutters snip off the sharp points.
One also needs to ream out each hole in order to insert the bolts, trying not to remove any protective galvanizing.
I had to devise a extension with a support handle to reach down inside where the three support tubes are welded on in order to grind away the glob of weld, then I had to purchase a can of cold Galvanizing paint to re coat inside.
The center rocket top tube was not welded on straight, not parallel with the support tubes it was welded on.
Being dipped in galvanizing leaves some drips that harden into tiny sharp points, one needs to go over each section and using side cutters snip off the sharp points.
One also needs to ream out each hole in order to insert the bolts, trying not to remove any protective galvanizing.
Found: 1
