ROHN 25GSSB Concrete Base Plate for 25G Self-Supporting Tower

ROHN SB25G5 5' foot Short Base Section for 25G Self-Supporting or Bracketed Tower
Made in the USA!
The ROHN SB25G5 is a 5 foot Short Base Section for Embedment in a poured Concrete Pad prior to erection of a 25G Bracketed or Self-Supporting Tower. This Short Base Section is set into a hole, with concrete poured around it and resting on top of gravel layer underneath to provide a Drained, Bolted and Fixed Connection to a 25G Main Tower or Top Cap Section which provide addition twist control.
If you are installing a Guyed 25G Series Tower, this ROHN SB25G5 5 foot Short Base can be used with a slightly deeper poured concrete pad in substitution of the ROHN SB25G 3 foot-4 inch Short Base called out for in the ROHN Pre-Engineered Guyed Tower Kits.

ROHN 25GBRM BRM6X Non-Penetrating Roof Mount Base for 25G Tower
Made in the USA!
The ROHN 25GBRM non-penetrating roof mount, is designed to support up to (2) 25G tower sections of 25G tower in self-supporting tower applications. The base of the roof mount is 10’ square with a 16” tray to fit the concrete blocks, typically used as ballast. Height and Antenna Loading capability are dependent upon ballast weight. You need to Consult an Engineer to determine the Load Bearing Capability of the roof that you are entertaining such an Installation. Please refer to the Chart (pdf link above) which is a great place to start in determining whether your circumstances qualify for such an installation. The mount is Hot Dip Galvanized for corrosion protection and goes together quickly.
This Item Ships LTL Freight ONLY!

ROHN BPC25G Concrete Base Plate for 25G Guyed Tower
Made in the USA!
The ROHN BPC25G uses a 3/4" x 12" pier pin to align the plate to the concrete slab and prevents Lateral Movement for ROHN 25G Guyed Tower installations only. This ROHN Base Plate is 15 inches Square and 3/16 Thick, allows the ROHN 25G Tower to be Mounted onto an existing or new Concrete Pier, Pad or Slab but Cannot be Used as a Self Supporting Base Plate.(see 25GSSB)
All 25G Tower Installations should be temporarily Guyed during erection.

ROHN BPH25G Hinged Base Plate for 25G Guyed or Bracketed Tower
Made in the USA!
The ROHN BPH25G Hinged Base Plate for 25G Guyed or Bracketed Towers is Bolted to a Concrete Pier Placement. The BPH25G is pre-drilled for use with six (6) 1/2 x 12 inch J-Bolts or Equivalent Embedded in Concrete Pier Pad during pour(Seek Engineering notes in Spec. Sheets, J-bolts Sold Separately), and Allows for the Tower to be Rotated up from Base during Installation. This ROHN Base Plate is 15 inches Square for the ROHN 25G Tower to be Mounted on a new or existing Concrete Pier. This Base for the 25G tower can be used in guyed or bracketed, but not self-supporting configurations according to specifications in the ROHN catalog.
All 25G Tower Installations should be temporarily Guyed during erection.
Consult ROHN Catalog Links at Footer Section below for ROHN 25G Tower Details.