Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools
Your Cart
Your shopping cart is empty!
Printer View Tell a Friend

Adjustable Eave Mount Antenna Mast Bracket

Price$32.50
Manufacturer Code3S-31
Qty
AvailabilityUsually ships in 24 Hrs
ShippingCan ship anywhere

Highlights

Accepts Mast up to 1.75 inch DIA
Adjustable from 45'' to 60''
Comes with Mast Clamps
Made in the USA!

12 Gauge Steel

Bulk Quantities Available Here!

EZ-31 Adjustable Eave Mount Antenna Mast Bracket


Made in the USA!Made in the USA!
Used for easy mounting on the eave of a house. Made of 12 gauge pre-galvanized steel, adjustable from 45 to 60 inches.Both the upper and lower brackets are for masts up to 1.75 inches in diameter with clamps, bolts and 1.5 inch lag screws. Mast will rest atop mantle shelf created by lower Bracket (Mast Not Included). Will stand-off mast 2.25 inches from surface.

 


Note

Typical rafter spacings are 16 inches center to center and pre-built trusses are 24 inches center to center.

Buyers Guide
Install Guide
Rate this product.
Product isn't rated yet. Write a review.

Eave & J Mounts For Antenna Mast Pipe

The first key to any reception is to get above obstructions that exist between you and your target, as radio frequency reception of any kind (satellite, microwave, Radio and TV) are for the most part "Line-of-Sight" dependant. The fact that some receptions occur without line of sight is due to phenomenon not applicable in this discussion. As you increase your target distance, you increase the territory you must account for in maintaining line-of-sight. What tall building and air traffic exist in this corridor, no one can account for. Aircraft are very good at messing up reception for a number of reasons, even when flying way above the path, again removed for clarity in this discussion. Height, is therefore key in optimizing your ability to capture the best line-of-sight possible to your target.

The Roof of any Building of Home provides a Logical Platform of Height in which Line-of-Sight is more likely to occur, or from which, more height can easily be obtained. These Mounts are Quality made by Manufacturers with a History in the Field of Proven Success and Longevity. Whether you are planning to Install your Antenna and Mount to the Roof Peak, Gable, Vent Pipe, Chimney or Pitch, Please plan your installation to Minimize the Structural and Asthetic Impact to your House or Building, research and follow all applicable Local Building Codes and annex the appropriate Structural Engineering Assistance when utilizing Non-Penetrating Mounts with Concrete Cinder Block Ballast on any Flat or Pitched Roof.

Products   Recently Viewed