Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools
Your Cart
Your shopping cart is empty!
Printer View Tell a Friend

Non-Penetrating Roof Mount FRM200 to FRM238 Adapter

Manufacturer CodeVMP-FRMA
AvailabilityUsually ships in 24 Hrs
ShippingCan ship Canada

VMP FRMA Non-Pen Roof Mount FRM200 to FRM238 Adapter
Converts the FRM200 2.00 inch OD mast pipe to a 2.375 inch OD Mount ideal for HughesNet, DirecWAY, StarBand Satellite Dish and Microwave Antenna Mounting, is constructed of steel, uses standard concrete blocks as Ballast.


The FRMA is an adaptor to convert an FRM-200 to a 2.375” OD masting. Simple to install and use the FRMA just slides over and existing assembled FRM-200 mast to convert the mast to a larger OD. This Non-Penetrating Mount Series from VMP is finished with a dark brown weather resistant powder coat inside and out that blends well with residential environments. The 2.375, 2.38, 2-3/8 inch Diameter Pipe size mounts HughesNet, DirecWAY and STARBAND Satellite Internet Dish Antenna, PR-TV and some SCALA UHF Antenna, Andrew, Gabriel and Blonder Tongue Microwave Parabolic Reflector Antennas. I have enjoyed Installing this product line for Dish applications from Business and Internet on the tops of tall buildings to HD TV and zillions of channels for in-home use. And as with all items in this Product Line, Screws and Pitch Pads are included for Bolt-down versus Ballast applications. The Length of the mast is 30 inches based on engineering that incorporates consideration for typical Satellite Antenna Wind-load versus the Ballast that would keep either on target with minimal deviation and flex. As with all Ballast mounts, Structural Engineering consultations are recommended for all Roof Applications.


Specification Sheet

Rate this product.
Product isn't rated yet. Write a review.

Flat Roof Non-Penetrating Mounts

These mounts can be used where penetrating its attachment is not an option. Non penetrating mounts use a balasest like your usual cement cinder block as a method to hold down your masting structure. They can help meet the variety of communication tower needs such as Cellular, PCS, Wireless Cable, Microwave, Wireless Internet, WiFi Hot Spots, DBS, MDS, MMDS and UHF/VHF reception.

Designed and engineered to handle the job of getting above ground interference, each non-penetrating roof mount has been researched and developed to serve a specific purpose.

With professionally engineered construction, you can be assured you're getting a virtually maintenance-free product built to the highest standards. And because our non-penetrating roof mounts are hot-dip galvanized after fabrication, our mounts won't rust.

    Additional Features Include
  • Offer both Fixed Mounts and Ballast Roof Mounts
  • Pre-Galvanized for corrosion protection
  • Varied mast heights available
  • Varied mast pipe O.D. available
  • Quickly shipped and quickly assembled
  • Minimum bolted connections
  • Engineering ballast tables available
  • Optional roof pads and mats available
  • All models are UPS shippable

Products   Recently Viewed