ROHN 25GWM Wall Mount Tower Base Assembly and Bracket Kit for 25G Towers
Made in the USA!
This ROHN 25GWM Wall Mount Tower Base Assembly and Bracket Kit allows you to wall mount the base of a bracketed 25G tower. This wall mount gives you the ability to install more load than is typically available on a standard wall mount. The wall mount also helps to keep the ground area around the tower location usable. Height and Load limits depend on wall and building attached to and shall be determined by you in consultation with your local Structural Engineer. The 25GWM assembly comes complete with both top and bottom wall mounting bracket materials and stub leg base plate for connection to a standard ROHN 25G tower section. ROHN Produces this series of Brackets specifically for the 25G Tower in exterior wall mount applications.
1. It is the Purchaser’s Responsibility to verify that Their installation and Building Structure are able to withstand all loads imposed by the antenna system and mount.
2. All antenna installations should be grounded, by installer, to meet all applicable codes.
3. All parts are hot-dip galvanized after fabrication.
4. All sealant to be supplied by others, if required.
5. Local Zoning, Building Codes and Insurance Companies may Require an Architect or Structural Engineer’s approval Prior to Installation.
6. Inspect the mount and antenna installation every 6 months and after severe weather.
7. Holes provided in mounting angles are 11/16” diameter for use with HDG 5/8“ threaded rod, provided by others.
Print this page
Download