3 Star Inc 3S-WM2 Antenna Mast Wall Mount 2 inch Heavy Duty W Style Bracket
Made in the USA!
Provides supplemental Wall Mount Support for Telescopic Antenna Masts or ANY TV Antenna Mast Pole from 1.00 to 2.00 Inch OD, so if mounting a Telescopic Mast, Check the Diameter of the Segment where you intend to mount as some diameters may be larger. Comes with a Set of 2 brackets including 2 inch Lag Bolt Hardware.
Manufacturers recommend that masts heights of 10 feet and higher above the uppermost bracket be guyed for Addition Wind Load Support. Bonding/Grounding should be made by affixment to Mast itself. Consult NEC and Applicable Local Code for further guidance
(Mast Not Included)
This "W" Style Wall Mount Bracket is Designed to Support Antenna Masts from 1.00 to 2.00 inches in Outside Diameter with 2 inches of standoff clearance from the Wall. This Bracket will provide support for Telescopic style masts, but not the weight of a Telescopic Antenna Mast itself off of the Ground. Set Screw installation may require pilot hole drilling of both Mast and Bracket. If you are Installing 2 inch or greater diameter masts or any mast greater than 10 feet in height above the bracket, run the Mast length all the way down to the Ground, resting the weight on an elevated base and/or Mast base plate (keep in mind that this bracket only provides a 2" standoff from wall) and affix an Earth Ground onto the mast with solid copper to a 5/8 inch diameter, 8 foot long Ground Rod as a minimum. Use a Mast Base Plate like EZ32A or GTMBL to mount the Bottom of a Telescopic Antenna Mast from the ground up, with the Wall Bracket maintaining vertical alignment and clearance from the Wall. These Mounts do not replace or otherwise reduce the need for proper guying of the Telescopic Antenna Masts.
Print this page
Download