HOLLAND HR-FPI 2 GHz Satellite and Antenna TV DC Power Inserter
This Indoor/Outdoor Power Inserter passes 15-2150 MHz (2.2 GHz) Wideband Satellite and/or Off-Air TV Antenna and Cable TV frequencies, inserts the DC voltage from an external supply (up to 35 VDC @ 1 Amp) for powering an In-Line Amplifier or LNB(F) farther upstream on the same coaxial cable. One Port Power Passive (passes DC Voltage in one Diection only). All connections in and out of this Inserter are made by RG coaxial cable "F" connectors, allowing for an outside installation. The actual Power Supply (not included) is usually plugged in on the inside of the premise, with a segment or RG59 or RG6 running from inside to out, connecting the two for this purpose. Grounding Block Attached, series uses Solder Back Case for 130 dB RF shielding. Holland's high performance passives are designed for distribution of digital satellite signals in applications where signal integrity is critical. The HRS and HR VS Series splitters utilize diode protected circuitry to prevent DC backfeeding.
When Splitting the High Frequencies of Satellite TV Services to feed multiple Receivers, the Loss associated with the splitter may need to be compensated for with the use of an In-Line Satellite TV Drop Amplifier (Signal Booster) specific to this purpose and Frequency Range. Consider the need and review the "Satellite TV Amplifier" category for selection. Most of these Satellite In-Line Amplifiers are line powered from the Satellite Receiver and will not, under most circumstances, require any externally coupled supply that this is intended to couple. If the receiver doesn't inject DC power for use by LNB(F)'s, or the segment of cable you need to amplify doesn't have DC Voltage on the line at that point, and you need to install an In-Line Amplifier there, this is the means to get power on that line!
This Power Inserter will pass Frequencies also associated with Cable TV and TV Antenna use. TV Antenna Pre-Amps usually include a Power Supply and Inserter, if you need an Inserter for this purpose, this one will do... Most In-Line Cable TV amplifiers also come with the aforementioned accessories, but if you are missing them, this Inserter will also fit the Bill...
Also, if you need to block the DC voltage from passing on either side of the Amplifier, use the VBC (Voltage Blocking Coupler, separate item) to block the DC voltage from passing to other devices and prevent damaging them!
Commensurate with Coaxial Cable TV Antenna and Satellite TV Power Inserter Installation, you want to Ground your Cable TV or HDTV Antenna Coaxial Cable System Outside before bringing the TV Cable Inside. This way, Lightning Strikes and Power Surges have an opportunity to arrest before reaching your Satellite Receiver and TV Set(s). The Integral Grounding Block designed onto most Outdoor Use Compatible Satellite Signal Splitters and Inserters we sell will effectively convey this unwanted Electrical Energy to a Ground Rod via a Copper Ground Wire that you Install (not included). Consult your Local Building Code and NEC for guidance to Properly Grounding your HD TV Antenna, Satellite TV, Cable TV, WI-FI, Wireless Internet, Business Band, CB or Amateur Radio Antenna Installation.
Print this page
Download