ROHN Style Single Side Arm Antenna Mount Assembly for 25G Series Tower

3 Star Inc 25MT Single Side Arm Antenna Mount Assembly for ROHN Style 25G Series Tower
Made in the USA!
This 25MT Mount is a Heavy Duty Assembly comprised of (2) 2.00" inch HDG Angle Iron crossmembers, each 4' feet long (48" inches), that on one side, perpendicularly cross and clamp to the two Rails of Any 25G Tower Series Section Face, parallel to each other with about 3'-4' feet spacing between them. On the other side, at the extended Crossmember ends, braces a 4'-5' foot Mast Pipe (Typical, Pipe OPTIONAL) resulting in an approx. 23-1/2" inch Stand-Off (Rail Center to Mast Pipe Center) on one Side of the Tower Section Face.
The The Assembly can mount an Antenna Mast Pipe diameter of 1-1/2 to 2-7/8 OD. on one side
The Angle Iron, OPTIONAL Mast Pipe and Saddle Clamps that Attach them all are Hot Dip Galvanized, and the Bolt Hardware is HDG Grade 5. These Single Side Arm Mounts are intended for Light Weight Broadband, WiFi ,SCADA and Narrow Beamwidth Two-way Antennas.
Will Fit most ROHN, Nello and American Towers G-Style Communications Tower Series.
A Product of 3 Star Inc

Includes:
(2) -4' L x 2.00" W x 3/16" Thick HDG Angle Iron Rail Mounts
(6) -HDG 3.50" inch Saddle Clamps
(12)-3/8" x 2-1/2" HDG Full Tread Bolt Assembly

Optional Mounting Pipe Sizes Available:
(1) -4' foot x 1.50" OD 14 Gauge HDG Pipe
(1) -4' foot x 2.00" OD 14 Gauge HDG Pipe
(1) -4' foot x 2.38" OD 14 Gauge HDG Pipe