3 Star Inc 25MT-DUAL ROHN Style Dual Side Arm Antenna Mount Assembly for 25G Series Tower
Made in the USA!
This 25MT-DUAL Mount is a Heavy Duty Assembly comprised of (2) 2.50" inch HDG Angle Iron crossmembers, each 4' feet long (48" inches), that perpendicularly cross and clamp to the two Rails of Any 25G Tower Series Section Face, parallel to each other with about 3'-4' feet spacing between them. On both sides, at the extended Crossmember ends, braces a 4'-5' foot Mast Pipe (Typical, Pipe OPTIONAL) that is clamped at both resultant corners, resulting in an approx. 15" inch Stand-Off (Rail Center to Mast Pipe Center) on Both Sides of the Tower Section Face.
The Assembly can mount an Antenna Mast Pipe diameter of 1-1/2 to 2-7/8 OD on both sides
The Angle Iron, OPTIONAL Mast Pipe and Saddle Clamps that Attach them all are Hot Dip Galvanized, and the Bolt Hardware is HDG Grade 5. These Single Side Arm Mounts are intended for Light Weight Broadband, WiFi ,SCADA and Narrow Beamwidth Two-way Antennas.
Will Fit most ROHN, Nello and American Towers G-Style Communications Tower Series.
A Product of 3 Star Inc
Includes:
(2) -4' L x 2.50" W x 3/16" Thick HDG Angle Iron Rail Mounts
(8) -HDG 3.50" inch Saddle Clamps
(16)-3/8" x 2-1/2" HDG Full Tread Bolt Assembly
Optional Mounting Pipe Sizes Available:
(1) -4' foot x 1.50" OD 14 Gauge HDG Pipe
(1) -4' foot x 2.00" OD 14 Gauge HDG Pipe
(1) -4' foot x 2.38" OD 14 Gauge HDG Pipe
Print this page
Download