ROHN AS25GTB Thrust Bearing Accessory Shelf with Hardware for 25G Tower Sections
Made in the USA!
The ROHN AS25GTB is used for Mounting a Thrust Bearing to a 25G Tower Section to suspend the weight and Wind Load of a Mast and Antenna off of the Antenna Rotor that would be mounted below. Drilled to fit the TB3 and TB4 bolt patterns, the plate is not drilled for, nor is it designed for use with an Antenna Rotator. The AS25G is Hot Dip Galvanized Steel with (3) U-Bolts to attach to all 3 Side Rails anywhere on a 25G Tower Section, usually somewhere above the Antenna Rotor Mount. In addition, the AS25G can be Mounted with Beacon Lighting anywhere needed along the 3 Side Rails of any 25G Tower Sections. Field Drilling may be necessary to accommodate the other aftermarket versions of Thrust Bearings so please verify and compare the bolt hole patterns. This AS25GTB Accessory Shelf can also be field drilled to accommodate the mounting of Beacon Lights and other Attachments.
The AS25GTB has a Centered 3" inch hole surrounded by an equidistant bolt pattern comprised of 4 bolt holes (0.56" DIA), 90 degree spaced in circumference around the 3" inch center hole with 5.38" inches across from each other center to center.
Print this page
Download