Print this page

180 Degree Hardline Extended Adapter 4.5"

Price: $12.95

Highlights:

75 Ohms

0 Mhz to 1 Ghz

180 Degree Adapter

4.5 inch

Availability: Usually ships in 1 week
Shipping: Can ship Canada
Weight: 0.25 lb

Description

PPC CPPA1804.5 180 degree Hardline Cable adapter 4.5 inch

180 degree extended adapter with set screw is designed for installations where space restrictions require nonaxial connections between cables and equipment. All adapters come standard with 2.15” length entry pins, weather-sealed joints and allow for entry of a .155 diameter center conductor , bandwidth 0 Mhz to 1 Ghz. , 75 Ohms

Note : Image provided for representation purposes only

Note:

INSTALLATION INSTRUCTIONS CPPA1804.5 1.

Loosen the equipment seizure screws. 2. Measure and trim the pin of the 180 Degree Adapter according to equipment manufacturer’s specification. 3. Thread the 180 Degree Adapter into the equipment housing approximately 3 1/2 turns. 4. Remove the cap of the 180 degree adapter and loosen seizure screw. 5. Trim the pin of the connector to 9/16” as shown below in the diagram. 6. Hand tighten the pin connector into the 180 Degree Adapter. Wrench tighten an additional 1/8 to ¼ turns while holding the adapter with another wrench. 7. Install the prepared cable into the pin connector and fully tighten per the connector installation instructions. 8. Finger tighten the seizure screw to the connector pin within the adapter, then tighten an additional 1/8 to ¼ turn with a screw driver or nut driver. 9. Hand tighten the jam nut of the 180 Degree Adapter to the equipment housing while holding the connector in position, then further tighten the jam nut with a wrench an additional 1/8 to ¼ turns. 10. Hand tighten the jam nut between the 90 degree blocks, then further tighten 1/8 to ¼ turns with a wrench.

Images

180-degree-extended-adapter.gif