ROHN TA553 Torque Arm Stabilizer Assembly Anti-Twist for 55G Guyed Tower

ROHN TA553 Torque Arm Stabilizer Anti-Twist Down Guy Assembly for 55G Tower
Made in the USA!
This ROHN TA553 Torque Arm Anti-twist Stabilizer Down Guy Assembly is to be located in the area of the Microwave or other Focused Beam antennas to provide six-way guying. Comes in 3 Structural Pieces that joint together via Top & Bottom Plates where each piece meets another, being assembled around the Tower Section. The Assembly then attaches to each of the (3) Tower Leg Rails with U-clamps, preferably resting above the Tower Section Joint Sockets. Torque Arm Lugs are provided.
CAN BE INSTALLED AFTER SECTIONS ARE JOINED TOGETHER ON EXISTING TOWERS.
You will Need (6) 5/8" Shackles with a thimble around each shackle to seat whichever size EHS Strand Big Grip Preform Dead-end to terminate the Down Guy. The Big Grips and Thimbles will depend on the size of the Guy wire to be used 3/16EHS,1/4EHS or 5/16" EHS Strand(See Spec Sheet for Illustration)

Warranty Sheet