ROHN SBH25GHDW Repair/Replacement Hinge Kit for SBH25G Hinged Base Section
Made in the USA!
The ROHN SBH25GHDW is a Primarily a Repair/Replacement Kit to Fix a Worn or Damaged SBH25G Hinged Short Base Section. It contains all the parts needed to replace the Hinged Rail Posts, Bolts and Nuts to make it like Brand New. Check the corresponding Base Section Holes for cracks or deformities that may render your base irreparable as to avoid further Damage or Injury.
The Hinged 25G Short Base Sections CANNOT be used in ANY Self-Supporting 25G Series Tower configuration, please refer to the ROHN SB25G5 5 foot Short Base as this part is called out for in the ROHN Pre-Engineered Self-Supporting Tower Kits.
You will need to make modifications to the existing embedded Base Section that neither ROHN nor 3 Star Inc warranties against Failure as the Buyer/Installer/User Assumes ALL Liability in Craftsmanship and Appropriate Use!
This kit is for a Base section ONLY and is not intended to be used on any Main Tower Section midway up the Tower.
Not for Freshman attempts as this is not a recommended Practice by ANY Means but; this kit can also supply you with the parts to convert an existing 25G fixed Base or Main Tower Section to a Hinged Section. Be sure that the Section you will Modify is oriented correctly so that you can Bracket or Down Guy the Tower as was Installed and still able to tilt the Tower Down away from Obstructions. Swaged Rail Posts are used ONLY to provide Bolted Connection into a 25G Main Tower, Top Cap Section or; from Base Section to be Embedded in Concrete or as part of a hinged connection section. Hot dipped galvanized for corrosion protection, the Kit includes Swaged Rail Posts, HDG Bolts, Nuts and Washers
Includes:
3 - 210011G 3/8x2-1/2 Grade 5 HDG Bolts
3 - 230005 3/8 Hex Nut HDG Bolts
3 - 250082 3/8 Split Lock Washer
1 - KH87 Stub Hinged Base Top
1 - KH88 Stub Hinged Base Right
1 - KH89 Stub Hinged Base Left
Print this page
