ROHN TA25 Torque Arm Stabilizer Anti-Twist Down Guy Assembly for 25G Tower
Made in the USA!
This ROHN TA25 Torque Arm Anti-twist Stabilizer Down Guy Assembly is to be located in the area of the Microwave or other Focused Beam antennas to provide six-way guying. Bolts to tower at any section joint and attached with joint bolts. Must be installed as sections are joined together. You will Need (6) 1/2" Shackles with a thimble around each shackle to seat whichever size EHS Strand Big Grip Preform Dead-end to terminate the Down Guy. The Big Grips and Thimbles will depend on the size of the Guy wire to be used 3/16EHS,1/4EHS or 5/16" EHS Strand(See Spec Sheet for Illustration)
Locate this Anti-twist device in the area of your Microwave Dish or Focused Beam Broadcast and Receive Antennas. Provides six-way guying, so be sure to account for the Total number of Guy wires appearing at each Tower Ground Anchor Location. Bolts to tower at any section joint, attached with joint bolts and must be installed as sections are joined together, so plan the Antenna Locations on the 25G Tower Before Assembly (Engineer the Wind Load accordingly). Install the Torque Arm Stabilizers as to not impede Installation or reception to other Antennas located on the same Tower or Adjacent Towers.
Print this page
Download