1/2x9TBE&J Turnbuckle for Tower Down Guy 1/2 x 9 inch Eye to Jaw

3S 1/2X9TBE&J Turnbuckle for Tower Down Guy 1/2" x 9" Eye to Jaw
Federal Spec FF-T-791B Type 1 Form 1; Forged, Hot Dip Galvanized, Open Body, Working Load Limit: 2200 lbs., Ultimate Strength: 11000 lbs. The Turnbuckle eye is elongated to reduce stress on eye and make it easier for Thimbles and other hardware to pass through.

• Weather Resistant
• Hot Dipped Galvanized Steel

Typical Use: For attaching and tensioning ROHN Tower Down Guy Terminations when utilizing 3/16" Strand (via 3/16" Pre-formed Dead-End with 5/16" Thimble or 3/16" Cable Clamps with 3/16THH Thimble), 1/4" Strand (via 1/4" Pre-formed Dead-End with 5/16" Thimble or 1/4" Cable Clamps with 1/4THH Thimble), and 5/16" Strand (via 5/16" Pre-formed Dead-End with 7/16THH Thimble or 5/16" Cable Clamps with 5/16THH Thimble) through the Eye, with the Jaw affixed to an anchor with an Integral Down Guy Equalizing Plate (like the GAC3455TOP and GAC5655TOP), or through a Closed Single Eye Anchor (like the GAS4303 and EZ 30)
Consult ROHN Catalog Links at Footer Section below for ROHN 25G 45G 55G 65G Tower Guy wire Details for Various Wind Loads.
Compare to ROHN R-1/2TBE&J 1/2 inch Eye to Jaw Turnbuckle!