Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools
Your Cart
Your shopping cart is empty!
Printer View Tell a Friend

ROHN BRM43510 Non Penetrating Roof Antenna Mount R-BRM43510

Manufacturer CodeBRM43510
Stock Level: 16
AvailabilityUsually ships in 24 Hrs
ShippingCan ship only within USA


No penetration on roof surface
Hot Dip Galvanized for corrosion protection
Designed for concrete block ballast mount
Goes together quickly
Minimum of bolted connections
Optional roof pads or mats are available

Bulk Quantities Available Here!

ROHN BRM43510 Non-Penetrating Roof Mount 3.50 inch x 10 foot Mast
Made in the USA!Made in the USA!
Mast Dimensions - 3” STD. Pipe (3-1/2 O.D.) x 10'
This roof mount is able to support various Antenna EPA's depending on wind and Ballast load (see details). The base of the roof mount is 6' - 6" square with a 16” tray to fit concrete blocks, typically used as ballast. The base mount and mast pipe are Hot dip galvanized for corrosion protection and go together quickly.


Height and Antenna Loading capability are dependant upon ballast weight... You need to Consult an Engineer to determine the Load Bearing Capability of the roof that you are entertaining such an Installation. Please refer to the Chart (pdf link above) which is a great place to start in determining whether your circumstances qualify for such an installation. If you cannot find someone local to evaluate the registered plans for your Flat Roof Structure, ROHN may be able to put you in contact with someone who can.


3d view icon

While holding the mouse pointer over the 3D object, click and hold one of the 3 mouse buttons at the same time moving the mouse to navigate.
Left Button: Orbits or Rotates the camera. Right: Pans the camera. Mouse Wheel/Middle: Zooms camera in/out.

3d orbit icon
Loading 3D
Auto Rotate Panning Zooming
Specification Sheet
Buyers Guide
Specification Sheet
Rate this product.
Product isn't rated yet. Write a review.