Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools
Your Cart
Your shopping cart is empty!
Printer View Tell a Friend

ROHN FRM150 Non Penetrating Roof Mount FRM150

Price$140.00
Manufacturer CodeFRM150
Qty
AvailabilityUsually ships in 24 Hrs

Highlights

No penetration on roof surface
Galvanized for corrosion protection
Designed for concrete block ballast
mount Goes together quickly
Minimum of bolted connections
Optional roof pads/mats available

Bulk Quantities Available Here!

ROHN FRM150 Non-Penetrating Roof Mount 1.50 x 30 inch Mast
Made in the USA!Made in the USA!
This roof mount is able to support various Antenna EPA's depending on wind and Ballast load (see details). The base of the roof mount is 3’ square with a 16” tray to fit concrete blocks, typically used as ballast for placement of various TV, Radio, Microwave, WiFi and Wireless Internet Antennas. The base mount and mast tube are 16 gauge Pre-Galvanized for corrosion protection and goes together quickly. Antenna and wind loads vs ballast weight are found in the spec sheet below.

 


Height and Antenna Loading capability are dependant upon ballast weight... You need to Consult an Engineer to determine the Load Bearing Capability of the roof that you are entertaining such an Installation. Please refer to the Chart (pdf link above) which is a great place to start in determining whether your circumstances qualify for such an installation. If you cannot find someone local to evaluate the registered plans for your Flat Roof Structure, ROHN may be able to put you in contact with someone who can.

 

Specification Sheet
Buyers Guide
Specification Sheet
Rate this product.
Product isn't rated yet. Write a review.


Products   Recently Viewed