ROHN H30 30' foot Telescopic Mast Outdoor Antenna Pole
ROHN
Made in the USA!
Used for Off-Air TV Antenna, Amateur (Ham) Radio, Wireless Internet Antenna, MMDS and Cell Phone Signal Booster, Emergency Dispatch and Public Utilities Installations. All aerial Telescoping push-up Masts are galvanized and come with hardware designed to support light duty aerial antennas. The unique ROHN design features interior tube flanging combined with a double crimped exterior tube to produce a stronger and more stable joint than most common mast. Each section extends deeper into the lower tubes than most designs, adding to the masts stability. Height listed describes the overall pipe length. Due to overlapping sections of pipe, the extended masts will be shorter. This Mast fully extends to about 27' Feet. The shipping dimensions are 10' feet x 4" x 4" and ships Freight Only to Commercial and Residential addresses.
Manufacturers recommend that masts heights of 10 feet and higher above the uppermost bracket be guyed for Addition Wind Load Support. Bonding/Grounding should be made by affixment to Mast. Consult NEC and Applicable Local Code for further guidance
(Antenna, Down Guys and Mounts not included).
35 ft extended Height
Mast Section Dimensions are:
(1) 10'0" length x 1.25" O.D. (16 AWG)
(2) 9'10" length x 1.50" O.D. (18 AWG)
(3) 9'04" length x 1.75" O.D. (18 AWG)
This Item Ships LTL Freight ONLY.
Installation Guidelines:
- Installation or dismantling of telescoping masts require professional contractors experienced with guyed masts.
- All installations must be bracketed or guyed.
- The pictured guy wire kit layouts are for a typical installation. Individual installation requirements may vary.
- Antenna load (top load) should not exceed an effective projected area (EPA) of 2 square feet (see your antenna specifications).
Download
Telescopic and Antenna Mast Wall Brackets 24 inch Standoff Y Style for 1.25 to 3.00 inch OD Mast
- $34.75
Telescopic and Antenna Mast Wall Bracket 30 inch Standoff Y Style for 1.25 to 3.00 inch OD Mast
- $24.95
Galvanized C-Clamp Half Saddle Clamps for Pipe Mount
These are the same Heavy Duty Hot Dip Galvanized Clamps and Jaws used in the Pipe to Pipe or Antenna Mast and Tower Leg to Pipe or Antenna Mast sets we sell here
These Clamps and Jaws come in progressive size ranges accommodating from 1 to 9 inches. Build your own pole to pole or cross over mounts, replace lost, rusted or broken hardware from existing mounts. We carry all the bits and pieces you need to repair, upgrade like threaded rods, nuts, washers, lock washers and clamps. These parts are all quality made and can withstand the test of time and the weather.
All of our pole to pole mounts parts can easily be shipped UPS.
