RGKG RSL Grounding Kit - 1 Leg
Rohn RSL Tower Grounding kit, per Rev. G, (1) 5/8” x 8’ ground rod, 7/16” IWRC stranded galvanized ground lead and clamps for one tower leg.
|GR-10||5/8 X 10 Foot Ground Rod Copper Clad|
|ADR25-21||LUG, GALVAN 6 - 250 ALCU|
|GRC-3/4||3/4 inch Bronzed Ground Rod Clamp|
|220830||SCREW CAP .25-20X1.00" S.S|
|220831||NUT .25-20 HEX S.S.|
|250081||WASHER .25 STD FLAT SS|
|IWRC||7/16 6x25 EIP IWRC RRL - 30'|
Commensurate with Coaxial Cable TV Antenna and Satellite TV Splitter Installation, you want to Ground your Cable TV or HDTV Antenna Coaxial Cable System Outside before bringing the TV Cable Inside. This way, Lightning Strikes and Power Surges have an opportunity to arrest before reaching your Satellite Receiver and TV Set(s). The Integral Grounding Block designed onto most Outdoor Use Compatible Satellite Signal Splitter we sell will effectively convey this unwanted Electrical Energy to a Ground Rod via a Copper Ground Wire that you Install (not included). Consult your Local Building Code and NEC for guidance to Properly Grounding your HD TV Antenna, Satellite TV, Cable TV, WI-FI, Wireless Internet, Business Band, CB or Amateur Radio Antenna Installation.
Ground Blocks and Proper Grounding are an Important, often overlooked, aspect of Your Over-all Cable TV, HDTV or Satellite Antenna Installation and Safety. Proper Grounding can also Reduce the Reception of Interfering RF Signals. Grounding of Masts, Antennas, Cable TV and other RF Distribution Systems are covered by the NEC. Grounding can be as simple as a 12 AWG Ground Wire connected a short distance away to a 8 foot 5/8" DIA Copper Ground Rod (not supplied) or Bonded to the Existing Power Ground by the Power Meter installed on the side of your Home or Office. You may notice that most new Cable TV, Satellite and TV Antenna Installations are effected in this Manner. However, most State and some Local codes will contain requirements that supercede that of the NEC. Please Refer to Your Local Building and Electrical Codes...