3S-FRM-F125 Non-Penetrating Front Mount

View Larger Image

Price$106.00

Manufacturer Code3S-FRM-F125

Qty

Add to Cart View Cart Shipping Calculator

AvailabilityUsually ships in 24 Hrs

Highlights

125" Mast O.D.

Off-Air Antennas
Wireless Antennas
Comes with Hardware

3S-FRM Base 12 ga

3S-FRM-F125 Non-Penetrating Front Mount -w- 60" x 1.25" Mast

Made in the USA!
Ideal for Light Off-Air TV , Wireless Internet Antenna , cameras and other applications mounting for ground and roof top installations, is constructed of pre-galvanized 12 ga. steel, uses 6 standard concrete blocks to anchor, 35" x 35" base. Mast pipe length will be 60" x 1-25" OD . Mast pipe is 18ga Pre-Galvanized for corrosion protection .....

Height and Antenna Loading capability are dependent upon ballast weight... You need to Consult an Engineer to determine the Load Bearing Capability of the roof that you are entertaining such an Installation. It is Important to choose a Mount and Mounting Location with a Picture of the Finished Installation in Mind. Be Sure to First select a location that lends itself to applying a Load without Compromising the Integrity of the Material you affix to. Most Decorative Finishes most often do not have the Strength to Hold a Weight or Pressure without fail. Further, Think about what's underneath the exterior. Is it stronger, or will it yield to Pressure over time also? Weather Proof the Installation to Maintain the Integrity of your Home. Next consider the Location over a Lifetime of Adjustments, does it lend itself to modifications in Height or Direction? Larger Antennas increase the surface area presented to air movement, Hence, Wind-load does increase. As the length of the mast increases from Its last attached point on the structure, the torque applied in cantilever also increases with Weight and Wind-Load, requiring a more substantive attachment and Load-Bearing material. Keep the Distance Minimal from the Antenna to the TV's and Equipment you feed, as to minimize loss and the need for Amplification.

Flat Roof Non-Penetrating Mounts

These mounts can be used where penetrating its attachment is not an option. Non penetrating mounts use a balasest like your usual cement cinder block as a method to hold down your masting structure. They can help meet the variety of communication tower needs such as Cellular, PCS, Wireless Cable, Microwave, Wireless Internet, WiFi Hot Spots, DBS, MDS, MMDS and UHF/VHF reception.

Designed and engineered to handle the job of getting above ground interference, each non-penetrating roof mount has been researched and developed to serve a specific purpose.

With professionally engineered construction, you can be assured you're getting a virtually maintenance-free product built to the highest standards. And because our non-penetrating roof mounts are hot-dip galvanized after fabrication, our mounts won't rust.