3S-SQ4-2 Clamp and Square U Bolt for 4x4 Post Supports Pipe 1.66” - 2” OD

Inline Parallel Mast Pole Tube to Pole or Pipe Mounts

Inline Parallel Mast Pole to Pole or Pipe Mounts accommodating 2-3/8" OD through 4-1/2" OD Mast Tube Pipe come HDG (Hot Dipped Galvanized) or with a Pre-Galvanized Plated Finish.
All are used to Fixate and Hold (2) poles to cross perpendicularly, one to the other, preferably from an integral Structure Member to another, or even Freestanding. An Example would be attaching a Vertical Mast Pole Tube to an existing Horizontal Welded Guard Rail at two levels (Top and Mid rail) utilizing (2) Crossovers as to maintain a Cantilever against Weight and Wind Loading on the Mast being installed.

If You need to attach a Perpendicular Running Mast Pole to a Structural Post or Rail, please refer to the "Mast Pole to Pole Crossover Mounts" Category in this section!

You can increase the amount of strength and holding power by utilizing multiple mounts space out over the length of the Mounting Pipe. There are many reasons you might need to use these mounts and they mostly involve the need to attach a pole to another pole to either extend the original or simply as an attachment point for prime placement location.

Both Pole to Pole and Crossover Mounts are designed to support most WiFi , PCS, Cellular, SCADA, TV and Other Light to Midweight antennas. Consult a Structural Engineer if meeting Wind Speed survivability ratings is necessary.

All of Our Mounts in this Category can easily be shipped UPS, depending on QTY Dimensional Weight.

Pole to Pole clamps in Parallel and Crossover

The Pole to Pole and Crossover Pole Mounts are designed to support most WiFi, PCS, Cellular, and TV antennas. The Pole to Pole Mounts allows you to vary the mounting pipe length and diameter.

All of our mounts are weather protected using either a HDG (Hot Dipped Galvanized) or a Pre-Galvanization finishing process for corrosion protection.

All of our pole to pole mounts can easily be shipped UPS.