50 FT RG11 Quad Shield Coaxial Cable for Underground Use
Comes Pre-made with Connectors already fitted on the Cable ends for Instant Install out of the Box for Direct Burial Cable TV and some Satellite and Antenna applications. This is really big cable with low RF Signal loss for Cable TV, some Satellite and Antenna applications where the Coaxial Cable RF / IF Signal Feed needs to be Installed Underground for long distances between Equipment and Premise. Low Signal Loss Underground Coaxial that Features a PE (Poly Ethylene) Jacket over Two layers of Bonded Alunimum Foil and (2) layers that total 100% Aluminum Braid, Bonded Foam Dialectric with a Copper Clad Steel Center Conductor. Perfect for HDTV, DTV, DBS, Cable TV, Master Antenna and Satellite Master antenna Applications with 1.0 GHz Bandwidth. Can Also be Utilized as an Underground Signal Feed Transmission line from Towers, Dishes, Antennas and Telephone Poles to Home, Office and Premise.
RG11 Cables for Cable TV Antenna and Satellite TV
We offer these RG11 cables with connectors made in various lengths to facilitate connections of the new Cable TV Antenna and Satellite TV Accessories we Sell here at 3 Star Inc. Each Cable is made from Quad Shield cable, with High Quality, Low Loss Connections. Made with Black Colored Jackets, from 25 to 200 feet in length.
RG11 (RG-11) is to 75 Ohm as RG213 or RG214 is to 50 Ohm cable. RG11 Cable featuring 60% Braided Shield is comprised of an Aluminum Foil bonded to the Foam Dialectric with Aluminum Braided Shield with 60% coverage. Quad Shield RG11 would denote alternating Aluminum Foil and Aluminum Braided Shield Layers, starting with the Bonded Foil Layer around the Foam Dialectric, with the best Quad Shield having 2 Layers of Braided Aluminum Shield, one of 60% and the 2nd at 40%. Tri-Shield RG11 will have 77% Braided Aluminum Shield Coverage Between 2 Layers of Aluminum Foil Shield, the 1st Foil Layer being Bonded to the Foam Dialectric. RG11 is the lowest loss Flexible Braided Shield Drop cable Commercially Manufactured for Satellite TV, TV Antenna and Cable TV usage. Use for distances over 150 feet or when every dB counts. For Cable with less loss than RG11, one would then have to avail themselves to Hardline Coaxial with a Single Solid Shield (typically Aluminum) that is pricey, but delivers commensurate Results for the Money. Most all RG11 Manufactured uses Aluminum Braided Shield, the difference of note being the amount of Aluminum Braid Coverage and the composition of the Center Conductor; Solid Copper vs. Copper Clad Steel. Copper Clad Steel will suffice in almost any utilization scenario, however most Satellite TV Operating companies will require Solid Copper Center Conductor to be used by their respective Sub-Contractor Installers for Maintainence and Warranty issues. This is due to the DC Voltage component being fed from the Receiver back to, and Powering the LNB(f)s mounted on the Satellite Dish. Unless the run is extremely long and the connectors applied are of dubious Quality, the DC Loop Resistance difference between Solid Bare Copper and Copper Clad Steel is negligible.
Sorry, we are offline,
click here to send us message
