3 Star Inc 3S-WM3 Antenna Wall Mount 4 inch W Style 3 inch Standoff Brackets for 1.00 to 2.50 inch OD Mast
Made in the USA!
The 3S-WM3 Antenna Mast Wall Mount Set of (2) Heavy Duty, Hot Dip Galvanized, stamp reinforced "W" Style Brackets with Hardware Included for a 3 inch Standoff Wall Support of Light to Medium Duty Antennas on Mast Poles from 5 to 10 feet long and from 1.00 to 2.50 inches in Outside Diameter for Off-air and OTA TV, UHF/VHF Radio, Remote Telemetry Control and Monitoring Stations, Cellular Date Gateways, WiFi, Wireless Internet, Receivers, Boosters and Repeaters.(Mast Not Included)
These mast mountings are typical and generally require the cantilever distance between the mounts be one quarter (1/4) to one third (1/3) of the mast length depending on Wind Load, starting from the bottom with 2 foot between brackets being a minimum distance. All Masts greater than ten feet in length, and/or 2" inches or greater in O.D. should be based upon and from the ground in rising up to the desired height.
Also for Telescopic Mast Poles comprised of 1.25", 1.50", 1.75", 2.00" and 2.25" Tubes nested together and then extended, these wall mounts can supplement structural support but are not designed to take the place of a Base in Supporting the weight of the Mast off the ground or guying. Be sure and check that the Tube segments you wish to wall mount will fit within the Outside Diameter Window specified that the Brackets will accommodate. Set screw installation may require some field drilling.
Manufacturers recommend that ALL masts above 10 feet from their uppermost support be Guyed
With more height in your installation, Grounding/Bonding is a recommended consideration.
Print this page
