Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools

My Cart

Your shopping cart is empty!

ROHN 25G Bracketed Tower Wall Mount Kit R-25GWM

Price$453.60
Manufacturer Code25GWM
Qty
AvailabilityUsually ships in 24 Hrs
ShippingCan ship anywhere
Highlights
Hot Dip Galvanized
Bolted Joints
Rail Clamps included
Can be used in:
Bracketed Config.s

Bulk Quantities Available Here!

ROHN 25GWM Tower Wall Mount Bracket Kit 

Made in the USA!Made in the USA!
The ROHN 25GWM allows you to wall mount the base of a bracketed 25G tower. This wall mount gives you the ability to install more load than is typically available on a standard wall mount. The wall mount also helps to keep the ground area around the tower location usable. The R-25GWM assembly comes complete with both top and bottom wall mounting bracket materials and stub leg base plate for connection to a standard ROHN 25G tower section.

 

1. It is the purchaser’s responsibility to verify that their installation and building structure are able to withstand all loads

imposed by the antenna system and mount.

2. All antenna installations should be grounded, by installer, to meet all applicable codes.

3. All parts are hot-dip galvanized after fabrication.

4. All sealant to be supplied by others, if required.

5. Local zoning, building codes and insurance companies may require an architect or structural engineer’s approval

prior to installation.

6. Inspect the mount and antenna installation every 6 months and after severe weather.

7. Holes provided in mounting angles are 11/16” diameter for use with HDG 5/8“ threaded rod, provided by others.



ROHN Produces this series of Brackets specifically for the 25G Tower in exterior wall mount applications. Sturdy and Adjustable, this galvanized American Steel bracket is no comparison to the ROHN Clone brackets you may find at other Sites. Buy ROHN, Buy American.
Specification Sheet
Spec Sheet
Rate this product.
Product isn't rated yet. Write a review.

Wall Mounts

Wall & Eave Mount Brackets

Wall & Eave Mount Brackets for Satellite TV Antenna Mast, Cellular Wireless Internet, Business Band and Telescopic Antenna MastsIt is Important to choose an Antenna Mount and Wall Mounting Location with a Picture of the Finished Antenna Installation in Mind. Be Sure to First select a location that lends itself to applying a Vertical, Cantilevered, Twisting Load without Compromising the Integrity of the Wall Material you affix to. Most Modern Exterior Decorative Wall Finishes most often do not have the Strength to Hold the Weight and Pressure of a Large TV Antenna under Wind Load without fail. Beams and Studs within the Wall are an Absolute Must to Locate when the Wall Composition is anything other than Solid wood or Concrete. Attach to these Strength Members. Further, Think about what's underneath the Wall exterior. Is it stronger, will it yield to Pressure over time as well? Sandwich additional Material (wood or steel) to the backside or both sides of the wall at the points where the mount attaches, as to distribute the load on relatively weak wall materials and to dampen vibration from Wind. Weather Proof the Installation to Maintain the Integrity of your Home. Next consider the Location over a Lifetime of Adjustments, does it lend itself to modifications in Height or Direction? Larger Antennas increase the surface area presented to air movement, Hence, Wind-load does increase. As the length of the mast increases from Its last attached point on the structure, the torque applied also increases with Weight and Wind-Load, requiring a more substantive attachment and Load-Bearing material. Keep the Distance Minimal from the Antenna to the TV's and Equipment you feed, as to minimize loss and the need for Amplification. Further, the NEC (National Electrical Code partly defines a good Ground connection as being as short as possible, you must affix a connection to a good Earth Ground prior to Premise entry or Bond to an existing one.