3S-SQ4 Clamp and Square U Bolt for 4x4 Post Supports Pipe 1.66” - 4” OD

3S-SQ2  U-Bolt , Square bend 1.66” OD to 2.75” OD

The Pole to Pole Mounts is designed to support most WiFi , PCS, Cellular, and TV antennas. The Pole to Pole Mounts allows you to vary the mounting pipe length and diameter, It is Pre- galvanized for corrosion protection

3S-MD-CL Heavy Duty Medium Mast Clamp and Round U Bolt

The Pole to Pole Mounts is designed to support most WiFi , PCS, Cellular, and TV antennas. The Pole to Pole Mounts allows you to vary the mounting pipe length and diameter, It is Pre- galvanized for corrosion protection

ROHN TB5125BA 5/16" Double Bend U-Bolt Cross-Over Clamp Assembly for 1-1/4" Antenna Mast Pole
Made in the USA!
This TB5125BA is a Medium Duty Hot Dip Galvanized (HDG) Double Bend 5/16" diameter U-Bolt and Strap that forms a Cross-Over Clamp Assembly for mounting a 1-1/4 inch OD Antenna Mast Pole to another Pole, Pipe or 25G ROHN Tower Leg Rail component perpendicularly at 90 degrees. This is typically used for the mounting of a TV, Wireless Internet, Cellular Gateway, UHF, VHF Antenna or Array, etc.

3 Star Inc CPP-HD275 Heavy Duty 1.50" to 3.00" OD Pipe to Pipe, Pole or Tower Crossover Clamp Set
This CPP-HD275 Heavy Duty Pipe to Pipe, Pole or Tower Perpendicular Cross-over Clamp Set mounts a 1.50" to 3.00 inch OD Pipe or Antenna Mast Pole at 90 degrees to another 1.00" to 3.00 inch OD Pipe, Tube or round Tower member component (i.e. 55G/65G RTL Tower Tube Cross-members) via (8) 1-1/2" Wide x 6" inch Long Hot Dip Galvanized (HDG) C-Clamps, and (4) 1/2" DIA x 8" inch HDG Threaded Rods. This is typically used for the mounting of Conduit on a Tower, Building or Roof, as well as Antenna(s) (TV, Wireless Internet, Cellular Gateway, MIMO, DBS, Satellite, Microwave, Panel, Dish and Array) usually attached to other masts and pipe, Tower legs, Railings, Balconies, Roof Tops, etc.