5' Foot x 1.50" inch OD Satellite TV Antenna Mast Pole Pipe Swaged | 3S-5-150S
3 Star Inc
This 5 Foot (60") by 1.50" OD 18 AWG swaged end Antenna Mast tube is galvanized for weather and used to extend any 1-1/4 inch 18 gauge antenna masts by fitting the swaged end of this mast into the open end of the other mast tube of the same diameter and gauge, thereby extending the existing mast an additional 5 feet to fit a Variety of Mounts for Flexibility In Antenna Mounting and Height Clearance.
Ideal as a TV, Radio, WISP, Wireless Internet, Cellular, DISH500 and DIRECTV Dish Antenna Mast (will NOT work for DIRECTVs SL3/5) for Ground or Wall mount Installation. There's a Big difference between 18 AWG and 16 AWG when it comes to joining Swaged to Straight Antenna Masts. You cannot mix and match 16 and 18 gauge masts so please, verify the mast you have before purchasing a complimenting swaged section. Be Sure and afford yourself 2 feet minimum, up to 1/3 of the overall mast length between the two wall mounts you would utilize in your TV antenna Installation. The Torque applied from wind load through cantilever to these mounts can be significant.
Manufacturers recommend that mast heights of 10 feet and higher be guyed.
(Mount Not Included)
Keystone Jack Module Inserts
A Keystone module is an industry standard type of wall jack used in residential and business environments. The system consists of a modular face plate to which jacks are mounted. Flush mount Keystone Wallplates will fulfill the most complicated station installation requirements through a wide selection of snap-in modules. A variety of jacks and connectors will fill the wall plate openings to meet your specific requirements of voice, data, audio, video, fiber optic, etc. The inserts are a snap to install and remove, giving you a highly adaptable system.
A keystone jack module is a standardized snap-in package for mounting a variety of low-voltage electrical jacks such as TV, Phone, LAN, Data, BNC, RCA or optical connectors into a keystone wall plate, surface-mount box, or a patch panel. Keystone modules have a commonly popular standardized rectangular face of 14.5mm wide by 16.0mm high and are held in place with a flexible tab. This allows them to be snapped into or out of a mounting plate with correspondingly-sized rectangular holes, called ports. All keystones, regardless of the type of jack they carry, are interchangeable and replaceable. This is what makes Keystone a popular choice in today's installations at Home or Office. Some keystones use a pass-though type connector, where there is a jack on both the front face as well as the rear side. Others only have a jack on the front and employ a different means for hard-wiring signal cables in the rear, such as a mini 110, insulation-displacement connector, crimp or solder connection.
