Easy Up EZ32 Base Plate for Telescopic Pole and Antenna Mast Ground Mount
Easy Up
Made in the USA!
This Easy Up EZ32 Galvanized 9x9 inch 16 gauge Base Plate and Pier pin style Stake is for Ground Level Elevation installation of Telescopic and ANY Antenna Mast Poles from 1.25 to 2.25 inch Outside Diameter in both Temporary and Permanent Base Mounting by placement upon a Gravel or Concrete Foundation with the Center Stake inserted into, and the Plate resting on top of, a (1) Foot Cubed bed of gravel or pad of Poured Concrete above surrounding soil elevation.(depending on soil and frost conditions) The Pier Pin Style Center Stake Rod is approximately 1" in OD and floats freely within the Mast Tube placed over it and is not fixated other than by the Down Guys installed to secure the mast from wind-load.
Will Also Accommodate Telescopic Masts:
ROHN H20 H30 H40 H50 and Easy Up TM-20 TM-30 TM-40 TM-50
Manufacturers recommend that masts heights of 10 feet and higher above the uppermost bracket be guyed for Addition Wind Load Support. Bonding/Grounding should be made by affixment to Mast. Consult NEC and Applicable Local Code for further guidance
This Base Plate can be used with ROHN H30, H40, H50 and Channel Master 1620, 1630, 1640, 1650, 1820, 1830, 1840, 1850 Telescopic (Push-up) Mast. You could also use this as a base plate for 2 inch or 1 and 1/4 inch O.D. Masts. This Plate can be cemented into the concrete Pad via the Pin provided. The word "Ground" as used in the description can be a bit of a misnomer; it does not provide a "Earth Ground" in and of itself, but rather is a junction component that rests on the ground or pad and should be Bonded to with a proper Earth Ground composed of a 5/8 inch by 8 foot Copper Clad Ground Rod as a minimum. Consult your Local Building Code and NEC for guidance to Properly Grounding your HD TV, WI-FI, Wireless Internet, Business Band, CB or Amateur Radio Antenna Installation.
Pre-Galvanized & Hot Dipped Galvanized Steel Pipe
Pre-Galvanized & Hot Dipped Galvanized Steel Pipe ,offers to meet a variety of communication tower needs such as Cellular, PCS, Wireless Cable, Microwave, Wireless Internet, WiFi Hot Spots, DBS, MDS, MMDS and UHF/VHF reception. Galvanization provides a protective zinc coating that prevents rust and corrosion from water or moisture over time.
Selecting Antenna Mast Pipe
Selecting the proper antenna mast pipe is crucial. Depending on the size of your antenna, it's EPA, weight and height all play a factor in selecting a supportive pole. When planning, it's best to have all the information you can get like outside diameter of your attaching method, the clearance of gutters, siding or other obstacles in the path of your erecting a mast or tower.
When selecting a pipe you will need to know the length, OD (outside diameter), whether the AWG is 16 or 18 (the smaller the number the thicker the steel) and whether you'll need any swaged ended pieces. You'll then need to select the proper mounting such as wall, roof or maybe a tripod mount
Here you will find standard straight pipe in 5' foot and 10' foot lengths. You can also find those same pipes with a special end called a swage. A swaged ended pipe allows you to attach several lengths of pipe together.
ROHN Swaged Masts are Designed for stacking with a Notch and Swage Feature that prevents twisting of one mast section to the other without a set screw.(as shown below)
| Swaged End | Straight End |
 |
 |
