FRM-238 Non-Penetrating Flat Roof Antenna Mount with 2.38" OD x 30" HD Mast
3 Star Inc
Made in the USA!
A 2.375 inch OD Mast Pipe Diameter is ideal for HughesNet, DirecWAY, StarBand Satellite Dish and Microwave Antenna Mounting. This 30 inch height mast is Heavy Duty, Commercial Grade for Commercial Installation. Such Heavier installs of Larger Dish style antennas on Commercial Properties would do well to install a tether such as the SCK150 (also available from 3 Star Inc).
Non-Penetrating Roof Mounts can be utilized within various weight restrictions depending on the Structural Composition of your flat roof, and when set up on a Rubber Mat or Pad, will protect surfaces such as Shingle and Tar, Pea gravel, Membrane and bare concrete without puncturing or marring and help distribute the weight evenly.
Ideal for Light Off-Air TV and Wireless Internet Antenna mounting, is constructed of pre-galvanized 12 Gauge steel, uses 8 standard concrete blocks as Ballast on a 35.5" x 35.5" Base Frame. Mast Pipe is Hot Dip Galvanized HDG.
The HDG 2.375, 2.38, 2-3/8 inch Diameter Pipe size mounts HughesNet, DirecWAY and STARBAND Satellite Internet Dish Antenna, PR-TV and some SCALA UHF Antenna, Andrew, Gabriel and Blonder Tongue Microwave Parabolic Reflector Antennas. And with a little Field Drilling, Screws and Pitch Pads are available as an option for Bolt-down versus Ballast applications. The Length of the mast is 30 inches based on engineering that incorporates consideration for typical Dish Antenna Wind-load versus the Ballast that would keep either on target with minimal deviation and flex. As with all Ballast mounts, Structural Engineering consultations are recommended for all Roof Applications.
Download
Flat Roof Non-Penetrating Mounts
These mounts can be used where penetrating its attachment is not an option. Non penetrating mounts use ballast weight like your usual cement cinder block as a method to hold down your masting structure. They can help meet the variety of communication tower needs such as Cellular, PCS, Wireless Cable, Microwave, Wireless Internet, WiFi Hot Spots, DBS, MDS, MMDS and UHF/VHF reception.
Designed and engineered to handle the job of getting above ground interference, each non-penetrating roof mount has been researched and developed to serve a specific purpose.
With professionally engineered construction, you can be assured you're getting a virtually maintenance-free product built to the highest standards. And because our non-penetrating roof mounts are hot-dip galvanized after fabrication, our mounts won't rust.
- Additional Features Include
- Offer both Fixed Mounts and Ballast Roof Mounts
- Pre-Galvanized for corrosion protection
- Varied mast heights available
- Varied mast pipe O.D. available
- Quickly shipped and quickly assembled
- Minimum bolted connections
- Engineering ballast tables available
- Optional roof pads and mats available
- All models are UPS shippable
Sorry, we are offline,
click here to send us message
