1.25" to 2 inch Pole to Pole or Pipe Antenna Mast 90° Cross-Over Clamp Set CPP-LD
3 Star Inc
Made in the USA!
This CPP-LD is a Light Duty 1.25" to 2 inch Antenna Mast Pole to Pole or Pipe Crossover Clamp Set for mounting a 1.25" to 1.75 inch OD Antenna Mast Pole perpendicularly at 90 degrees to another 1.50" to 2 inch OD Pipe, Tube or Round Tower member component via Galvanized U-Bolts and Alligator Clamps. This is typically used for the mounting of TV, Wireless Internet, Cellular Gateway, MIMO, UHF, VHF, Weather Station or Telemetry Antenna Mast Poles and Pipe usually attached to another Mast, Pipe, Tower leg, Railing, Balcony, Roof Top, etc. This Crossover Clamp Set Is also used in the 3S-CLM Cantilever Dual/Double Antenna mount with a 1.66 U-Bend Mast Pipe.
Includes U-bolts, Clamps and Nuts, Pipe and Mast Tubes are Not included but are available separately
Refer to "Specification" Tab above for More Detailed Information.
Specifications
- (2) Round Bend U-Bolts (2-1/8" Wide x 4-1/2" Long)
- (2) Galvanized Alligator Clamps (3" wide)
- (4) FLG nuts
- Maximum Tubing Size: 2.00" OD on One Side x 1.75" OD on The Other
Pipe to Pipe or Mast Pole to Tower Leg Crossover Clamp Sets and 90° Perpendicular Mounts
Crossover Mounts accommodating 2-3/8" OD through 4-1/2" OD Mast Tube Pipe are HDG (Hot Dipped Galvanized).
Crossover Mounts accommodating 1.00" OD through 2.25" OD Mast Tube are of a Pre-Galvanized Plated Finish.
All are used to Fixate and Hold (2) poles to cross perpendicularly, one to the other, preferably from an integral Structure Member to another, or even Freestanding. An Example would be attaching a Vertical Mast Pole Tube to an existing Horizontal Welded Guard Rail at two levels (Top and Mid rail) utilizing (2) Crossovers as to maintain a Cantilever against Weight and Wind Loading on the Mast being installed.
If You need to attach a Vertically Running Mast Pole to the Vertical Post, please refer to the "Pole to Pole Mount" Category in this section!
You can increase the amount of strength and holding power by utilizing multiple mounts space out over the length of the Mounting Pipe. There are many reasons you might need to use these mounts and they mostly involve the need to attach a pole to another pole to either extend the original or simply as an attachment point for prime placement location.
Both Pole to Pole and Crossover Mounts are designed to support most WiFi , PCS, Cellular, SCADA, TV and Other Light to Midweight antennas. Consult a Structural Engineer if meeting Wind Speed survivability ratings is necessary.
All of Our Mounts in this Category can easily be shipped UPS, depending on QTY Dimensional Weight.
