3 Star Inc 5994 1.66 to 2 Inch OD Combination Satellite Dish TV Antenna Mast Pole Pipe
This Antenna Mast Pipe features 1.66" OD on one end with 2.00" OD on the other end of a 28" long 16 AWG Galvanized Antenna Mast Pole Pipe.
Manufacturers recommend that mast heights of 10 feet and higher be guyed.
(Mount Not Included)

ROHN BRM42510 Non-Penetrating Roof Antenna Mount 2.38 in. x 10 ft. Mast
Made in the USA!
Mast Dimensions - 2” STD. Pipe (2.38 O.D.) x 120"
This roof mount is able to support various Antenna EPA's depending on wind and Ballast load (see details). The base of the roof mount is 6' - 6" square with a 16” tray to fit concrete blocks, typically used as ballast.
This Item Ships LTL Freight ONLY.

Easy Up EZ NP-175 Non-Penetrating Flat Roof Mount BASE ONLY for 1.00"-1.75 inch OD Antenna Mast
Made in the USA!
The EZ NP-175 is a Flat Roof Mount Frame-Only Option that allows you to supply and support your own Antenna Mast from 1.00 to 1.75 inches in Outside Diameter and from 30 to 60 inches (5 ft.) in height for Light Off-Air TV, Cellular, Wireless Internet, SCADA, CCTV, Telemetry and Small Diameter Narrow Beam-width Antenna placement. It can be configured as a Non-Penetrating, Guyed or Screw-down installation on a Flat Roof or at Ground level, and comes with assembly hardware. Non-Penetrating installations typically use (6) Standard Sized (8 x 8 x 16 inch) Concrete Blocks (Not Included) as Ballast Weight placement upon the 28.5 x 35.5 inch Pre-galvanized Rectangular Frame Base, with a Mat or Pad underneath (available separately) as to avoid roof membrane marring and penetrations.
The Frame comes with ALL Assembly Hardware Minus the mast that You supply. Your Mast will have to be drilled at the bottom to pass a 1/4-20 bolt (included) that will secure it to the Frame Base.

3 Star 500' #10 Solid Copper Ground Wire
25 feet of #10 Solid Copper wire as used for common grounding applications involving Low-Voltage Communications installations like Cable TV, TV Antenna, Satellite TV and Wireless Internet. Priced and sold by in continuous roll (500 ft. per unit ordered)...

ROHN 160505GHS 5 Foot Tall by 1.25 inch OD 16 AWG HDG Swaged Antenna Mast Pole Pipe
Made in the USA!
This 5 Foot (60") by 1.25" OD 16 AWG Medium to Heavy Duty Swaged-end Outdoor Antenna Mast tube is Hot Dip Galvanized (HDG) for Extreme Weather Resistance and adds a layer of zinc in the process which may make fitment difficult with other pre-galvanized (Non-HDG) Swaged-end Masts. If you are Looking to increase height by multiples of 5 foot using HDG 16 AWG masts, we recommend that you use the ROHN 5-16S Swaged-end HDG Masts solely, which are notched on the receiving end in addition to being swaged on the other for stacked fitment with another swaged section.
Manufacturers recommend that mast heights of 10 feet and higher be guyed.
(Mount Not Included)