ROHN KY2068A16 Dish Antenna Heavy Duty Mount with 1.66" OD Mast for 25G Tower
ROHN
Made in the USA!
ROHN KY2068A16 DBS Dish Antenna Mount with 1.66" inch x 3' foot OD Mast is a Hot Dip Galvanized, Sturdier Side Arm Assembly for DBS Satellite Dish Antenna Mounting on the ROHN 25G Tower. The Installation of a ROHN TA25 Tower Torque Arm Stabilizer Assembly Anti-twist device located in the area of the Antennas may be advantageous.
KY2068A15 - 1.50 inch O.D. x 3 Foot Pipe
KY2068A16 - 1.66 inch O.D. x 3 Foot Pipe
KY2068A2 - 2.38 inch O.D. x 3 Foot Pipe
ROHN KY2068A16 is a Hot Dip Galvanized Mounting Pipe Version of this DBS (Direct Broadcast Satellite) Side Arm Antenna Mounting Assembly for the ROHN 25G Tower. Depending on the Type of ROHN 25G Tower Installation and Height that you have, an Anti-Twist Guying Mount like the ROHN TA25 may reduce Satellite Signal loss due to Sway and Wind Load Flexing. The ROHN DDM166 is a Pre-Galvanized (Mounting Pipe is Lighter, Galvanized, then tooled and Machined into Finished Product) Version of this Item.
Download |
 The tabulated allowable effective projected areas (EPA) are limited to a maximum recommended value of 80 (ft2). EPA values shown as " - " indicate tower kit is not applicable for the corresponding wind speed. Site-specific designs are available upon request. TUBE BRACING |
 |
 The tabulated allowable effective projected areas (EPA) are limited to a maximum recommended value of 80 (ft2). EPA values shown as " - " indicate tower kit is not applicable for the corresponding wind speed. Site-specific designs are available upon request. TUBE BRACING |
