ROHN KY2068A16 Dish Antenna Heavy Duty Mount with 1.66" OD Mast for 25G Tower
ROHN
Made in the USA!
ROHN KY2068A16 DBS Dish Antenna Mount with 1.66" inch x 3' foot OD Mast is a Hot Dip Galvanized, Sturdier Side Arm Assembly for DBS Satellite Dish Antenna Mounting on the ROHN 25G Tower. The Installation of a ROHN TA25 Tower Torque Arm Stabilizer Assembly Anti-twist device located in the area of the Antennas may be advantageous.
KY2068A15 - 1.50 inch O.D. x 3 Foot Pipe
KY2068A16 - 1.66 inch O.D. x 3 Foot Pipe
KY2068A2 - 2.38 inch O.D. x 3 Foot Pipe
ROHN KY2068A16 is a Hot Dip Galvanized Mounting Pipe Version of this DBS (Direct Broadcast Satellite) Side Arm Antenna Mounting Assembly for the ROHN 25G Tower. Depending on the Type of ROHN 25G Tower Installation and Height that you have, an Anti-Twist Guying Mount like the ROHN TA25 may reduce Satellite Signal loss due to Sway and Wind Load Flexing. The ROHN DDM166 is a Pre-Galvanized (Mounting Pipe is Lighter, Galvanized, then tooled and Machined into Finished Product) Version of this Item.
DownloadROHN Tower Antenna Mount and Assemblies
ROHN Tower Antennas Mounts for All Series. Select by the ROHN Tower Series and choose between Tower Top Antenna Mounts, Tower Apex Antenna Mounts, Tower Side Arm Antenna Mounts with or without Tiebacks and Tower Face Antenna Mounts. These Mounts will differ based on the Type of Antenna, the Size of the Mast Pipe, Pole or Tube it is designed to be Mounted on and the Tower Leg Size it will be Mounted to. These Mounts were Primarily Engineered for ROHN G Series to include 25G 45G 55G 65G, RTL Towers, RSL Towers and SSV Towers. As there are Other Manufacturers with Similar Engineering in Their Communications Tower Series, you would find that some of the Antenna Tower Mounts will fit other Branded Towers as well.
Sorry, we are offline,
click here to send us message
