ROHN H50 50' foot Telescopic Mast Outdoor Antenna Pole
ROHN
Made in the USA!
Used for Off-Air TV Antenna, Amateur (Ham) Radio, Wireless Internet Antenna, MMDS and Cell Phone Signal Booster Installations (not included). All Telescoping push-up Masts are galvanized and come with hardware designed to support light duty antennas in various applications. The unique ROHN design features interior tube flanging combined with a double crimped exterior tube to produce a stronger and more stable joint than most common mast. Each section extends deeper into the lower tubes than most designs, adding to the masts stability. Height describes the overall pipe length. Due to overlapping, extended masts will be shorter. This Mast extends to 43 Feet in actual height that ships to Commercial and Residential addresses alike.
Manufacturers recommend that masts heights of 10 feet and higher above the uppermost bracket be guyed for Addition Wind Load Support. Bonding/Grounding should be made by affixment to Mast. Consult NEC and Applicable Local Code for further guidance
(Antenna, Down Guys and Mounts not included).
43 ft extended Height
Mast Section Dimensions are:
(1) 10'0" length x 1.25" O.D. (16 AWG)
(2) 9'10" length x 1.50" O.D. (18 AWG)
(3) 9'04" length x 1.75" O.D. (18 AWG)
(4) 8'10" length x 2.00" O.D. (18 AWG)
(5) 8'04" length x 2.25" O.D. (18 AWG)
This Item Ships LTL Freight ONLY.
Installation Guidelines:
- Installation or dismantling of telescoping masts require professional contractors experienced with guyed masts.
- All installations must be bracketed or guyed.
- The pictured guy wire kit layouts are for a typical installation. Individual installation requirements may vary.
- Antenna load (top load) should not exceed an effective projected area (EPA) of 2 square feet (see your antenna specifications).
Download
Use an HDMI splitter to send multiple HDMI signals to other HDMI displays, inputs or HDTV's. A Multiple number of Displays/Inputs can be connected by Daisy-chaining Multiple Splitters together to create a larger number of Distribution Outputs (Inputs to Other Devices). These HDMI Splitters support both HDMI Audio and HDMI Video signals within the HDMI signal and are fully HDCP Compliant. The HDMI Splitter is connected using a HDMI cable from the HDMI source to the HDMI splitter input. Then you connect 2 or more HDMI cables from the HDMI splitter output to you HDMI equipped HDTV or other device.
Sorry, we are offline,
click here to send us message
