ROHN R-CPC.5/.75 Anchor Rod Ground Clamp
ROHN CPC.5/.75 Guy Anchor Rod Ground Clamp
Used for Ground Connection to ROHN Tower down guy concrete Anchor Rods (0.375 to 1.00 inch actual OD range). Lug connects the 7/16 6x25 EIP IWRC RRL wire rope utilized in REV. G Grounding Kits (not included)... Harger CPC Pipe Ground Clamps compare to Burndy GAR
Made to connect to the Rod Section components of a ROHN Tower Down Guy Anchor as these Rods are within the nominal OD range above. This Clamp will also connect the Solid/Stranded Copper or Woven Rope Ground Wire lead to the Ground Rod on the other end, completing your Grounding (Lightning Protection) System. Typically, 3 (or multiples thereof) of these Clamps are used per Tower Installation as most Systems will dictate that a separate Ground Connection be made to all three Tower Down Guy Anchors. AGK1GGX Grounding Kits do not come with this component unless included in a Complete ROHN Guyed Tower Kit.
DownloadGround your Coaxial Cable System
Commensurate with Coaxial Cable TV Antenna and Satellite TV Splitter Installation, you want to Ground your Cable TV or HDTV Antenna Coaxial Cable System Outside before bringing the TV Cable Inside. This way, Lightning Strikes and Power Surges have an opportunity to arrest before reaching your Satellite Receiver and TV Set(s). The Integral Grounding Block designed onto most Outdoor Use Compatible Satellite Signal Splitter we sell will effectively convey this unwanted Electrical Energy to a Ground Rod via a Copper Ground Wire that you Install (not included). Consult your Local Building Code and NEC for guidance to Properly Grounding your HD TV Antenna, Satellite TV, Cable TV, WI-FI, Wireless Internet, Business Band, CB or Amateur Radio Antenna Installation.
Grounding & Bonding Are Important
Ground Blocks and Proper Grounding are an Important, often overlooked, aspect of Your Over-all Cable TV, HDTV or Satellite Antenna Installation and Safety. Proper Grounding can also Reduce the Reception of Interfering RF Signals. Grounding of Masts, Antennas, Cable TV and other RF Distribution Systems are covered by the NEC. Grounding can be as simple as a 12 AWG Ground Wire connected a short distance away to a 8 foot 5/8" DIA Copper Ground Rod (not supplied) or Bonded to the Existing Power Ground by the Power Meter installed on the side of your Home or Office. You may notice that most new Cable TV, Satellite and TV Antenna Installations are effected in this Manner. However, most State and some Local codes will contain requirements that supercede that of the NEC. Please Refer to Your Local Building and Electrical Codes...
Sorry, we are offline,
click here to send us message
