ROHN Telescopic Antenna Mast Universal Roof Peak Ridge Mount R-UM40
ROHN UM40 Telescopic Antenna Mast Universal Roof Peak Ridge Mount
Made in the USA!
is completely Assembled for quick and easy Flat or Peaked Roof Mount Installation for ROHN H40 and Channel Master 1640, 1840 Telescopic Push Up Antenna Masts. Allows tall masts to be swung up along the ridge of the roof. The Bottom of Mast Inserts into the Hinged Base for Antenna Masts up to 2.00 inches in Diameter, secured by Set Screw. Bonding should be made by affixment to Mast. Consult NEC and Applicable Local Code for further guidance. All Telescoping Antenna Masts are galvanized and come with hardware. The unique Rohn design features interior tube flanging combined with a double crimped exterior tube to produce a stronger and more stable joint than most common mast. Each section extends deeper into the lower tubes than most designs, adding to the mast's stability. Height describes the total pipe length. Due to overlapping, extended masts will be shorter.
Antenna Mast Roof Mounts
There is no substitute of height, clear line-of-site and size does matter... The higher the frequency, the higher the loss... Amplifiers do not give you something that you didn't have already...
The first key to any reception is to get above obstructions that exist between you and your target, as radio frequency reception of any kind (satellite, microwave, Radio and TV) are for the most part "Line-of-Sight" dependant. The fact that some receptions occur without line of sight is due to phenomenon not applicable in this discussion. As you increase your target distance, you increase the territory you must account for in maintaining line-of-sight.
What tall building and air traffic exist in this corridor, no one can account for. Aircraft are very good at messing up reception for a number of reasons, even when flying way above the path, again removed for clarity in this discussion. Height, is therefore key in optimizing your ability to capture the best line-of-sight possible to your target.The Roof of any Building of Home provides a Logical Platform of Height in which Line-of-Sight is more likely to occur, or from which, more height can easily be obtained.
These Mounts are Quality made by Manufacturers with a History in the Field of Proven Success and Longevity. Whether you are planning to Install your Antenna and Mount to the Roof Peak, Gable, Vent Pipe, Chimney or Pitch, Please plan your installation to Minimize the Structural and Asthetic Impact to your House or Building, research and follow all applicable Local Building Codes and annex the appropriate Structural Engineering Assistance when utilizing Non-Penetrating Mounts with Concrete Cinder Block Ballast on any Flat or Pitched Roof.
Sorry, we are offline,
click here to send us message