Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools
Your Cart
Your shopping cart is empty!
Printer View Tell a Friend

ROHN Tower Concrete Base Plate Pier Pin R-15/16X16PP

Manufacturer Code15/16X16PP
AvailabilityCall to Order
ShippingCan ship anywhere


Hot Dip Galvanized
Concrete Pier Placement
3/4 inch DIA by 12 inch Length
Can be used 25G 45G in:
Guyed Config.s

Bulk Quantities Available Here!

ROHN 15/16X16PP Pier Pin Insert for 65G / 80 Tapered Base
The 65G and 80 Series Tapered Base Sections rely on a 15/16 inch DIA x 16 inch long Galvanized Steel pier pin to align the Tapered Base to the slab (available as a Separate Item) and thus allows the ROHN 65G or 80 Tower to be Mounted onto a Concrete Pier.

Rate this product.
Product isn't rated yet. Write a review.

Since there are various other Manufacturers of Towers and Tower accessories that copy the ROHN Tower design, if you are not sure of the manufacturer of your Tower, you can at least compare the actual measurements and design of yours to those found in the spec. sheets in the ROHN catalog section via the Link provided above to assure yourself that additional sections or parts will fit. We cannot make that determination for you as the ROHN clones are something we don't carry or otherwise represent in our Product line. All towers in the GT Series are constructed with high strength steel tubing and feature ROHN's exclusive Zig-Zag ® solid rod bracing to provide exceptional strength. All GT Series Towers are hot dip galvanized after fabrication. In this process, each section of the tower is totally immersed in molten zinc, allowing every square inch of the tower, inside and out, to be completely covered. Hot dip galvanizing protects all points of welding and construction against rust and corrosion while providing an attractive finish.

The 65G is a true multi-use structure that provides excellent strength for applications up to 500´ with heavy steel tube legs to satisfy a wide variety of needs under varied conditions. When properly installed, the standard tower will support the loads shown on various guyed and self-supporting information sheets in the ROHN catalog.

Most Restrictions Allow for 40 feet of Height without the Necessity of Guy Wires, Anchors or Braces. However, No Tower is self supporting during construction! Always use temporary guys on the top most section, and install permanent guy wires as soon as a guy point height is reached.

ROHN 65G Buyers Guide

ROHN 65G Buyers Guide

Get Adobe Reader

This Buyers Guide will answer many questions you may have on this Product Line.

Products   Recently Viewed