10 Foot Roof Mount Tripod for Telescopic Antenna Mast
3 Star Inc. EZ 40 10 Foot Telescopic Antenna Mast Tripod Peak Roof Mount
Made in the USA!
10 Foot Tripod with 1.75 inch O.D. mast capacity conforms to roof peaks with installer friendly front facing feet that can accomodate 12 inch center rafters. Use with the EZ 19B Roof Base Plate. Masting will still require Down Guys. Can be Used with Off-Air HDTV or Wireless Cable and Wireless Internet Antennas. (Pitch Pad Kit, Mounting Hardware Not Included)
This Tripod is made to accomodate 1.75 inch diameter masts.
ROHN 45GSR Tower Sections, Bases and Top Plates
Since there are various other Manufacturers of Towers and Tower accessories that copy the ROHN Tower design, if you are not sure of the manufacturer of your Tower, you can at least compare the actual measurements and design of yours to those found in the spec. sheets in the ROHN catalog section via the Link provided above to assure yourself that additional sections or parts will fit. We cannot make that determination for you as the ROHN clones are something we don't carry or otherwise represent in our Product line. All towers in the GT Series are constructed with high strength steel tubing and feature ROHN's exclusive Zig-Zag ® solid rod bracing to provide exceptional strength. All GT Series Towers are hot dip galvanized after fabrication. In this process, each section of the tower is totally immersed in molten zinc, allowing every square inch of the tower, inside and out, to be completely covered. Hot dip galvanizing protects all points of welding and construction against rust and corrosion while providing an attractive finish.
The 45GSR is a true multi-use structure that provides excellent strength for applications up to 340´. It´s offered with solid steel rod legs to satisfy a wide variety of needs under varied conditions. When properly installed, the standard tower will support the loads shown on various guyed and self-supporting information sheets in the ROHN catalog.
Most Restrictions Allow for 45 feet of Height without the Necessity of Guy Wires, Anchors or Braces. However, No Tower is self supporting during construction! Always use temporary guys on the top most section, and install permanent guy wires as soon as a guy point height is reached.
Wind Loading, Antenna Loading and Wind Survivability ratings vs. Height Documentation Provided by ROHN is available here as a Resource, but is by no means complete by itself or a substitution for Engineering Conducted Specific to your Application. Contact Us with any Questions you may have regarding Use prior to Purchase. All Information regarding the ROHN 45GSR Tower line, Parts and Accessories is as accurate and complete as we can possibly provide given that this Resource Offering is subject to change without Notice and is beyond Our Control.
This Buyers Guide will answer many questions you may have on this Product Line.
