Telescopic and Antenna Mast Wall Brackets 24 inch Standoff Y Style for 1.25 to 3.00 inch OD Mast
3 Star Inc
Made in the USA!
The WM24W Antenna Mast Wall Bracket Set of (2) Double "Y" Style Brackets, One with a Vertical Brace Strut on the Bottom Bracket, with Hardware Included for a 24 inch Standoff Wall Bracing of Light to Medium Duty Antennas on Mast Poles from 5 to 10 feet long and from 1.25 to 3.00 inches in Outside Diameter for Off-air and OTA TV, UHF/VHF Radio, Remote Telemetry Control and Monitoring Stations, Cellular Date Gateways, WiFi, Wireless Internet, Receivers, Boosters and Repeaters.(Mast Not Included)
These mast mountings are typical and generally require the cantilever distance between the mounts be one quarter (1/4) to one third (1/3) of the mast length depending on Wind Load, starting from the bottom with 2 foot between brackets being a minimum distance.
All Masts greater than ten feet in length, and/or 2 inches or greater in O.D. should be based upon and from the ground in rising up to the desired height.
Also for Telescopic Mast Poles comprised of 1.25", 1.50", 1.75", 2.00" and 2.25" Tubes nested together and then extended, these wall mounts can supplement structural support but are not designed to take the place of a Base in Supporting the weight of the Mast off the ground or guying. Be sure and check that the Tube segments you wish to wall mount will fit within the Outside Diameter Window specified that the Brackets will accommodate. Set screw installation may require some field drilling.
Manufacturers recommend that ALL masts above 10 feet from their uppermost support be Guyed
With more height in your installation, Grounding/Bonding is a recommended consideration.
This "Y" Antenna Mast Wall Mount Bracket with 3rd Leg Support is Designed for Wall Mount Support of Antenna Masts of all Diameters from 1.25 inch to 3 inches with 24 inches of clearance from the Wall with the added reinforcement of a 3rd leg that goes to transfer the weight load leverage to the wall, but not the weight of a Telescopic Antenna Mast or ANY Mast greater than 10 Feet in Height (Depending on Antenna size!) off of the Ground and on the Wall alone. Use a Ground Plate like EZ32A or GTMBL to mount the Bottom of a Telescopic Antenna Mast from the ground up, with the Wall Bracket maintaining vertical alignment and clearance from the Wall to pass Roof edge. These Mounts do not replace or otherwize reduce the need for proper guying of the Telescopic Antenna Masts. As with all Masts, Guy wire support and Grounding are Critical to Antenna Survival.
Download
The most Popular Connector Series from Manufacturers like PCT, PPC, F-Conn, Thomas and Betts, Holland Electronics, Apica and Digicon offered in Legacy Hex Crimp styles as well as the Newer Radial Compression formats. Be Sure and match Connectors to their respective Crimping Tools by Manufacturer Spec. Sheet for Hex Diameter size or Compression length. Coaxial Cable Connectors should be weather protected in outdoor use, and some connectors provide extra moisture migration protection when compared to others. Though the economics of Old school Hex Crimp connectors and Tools may be attractive at first, over the long haul, compression connectors offer greater Shield Connection integrity, Bandwidth, Interference Rejection and Impedance matching when compared to their Hex Crimp counterparts. Whenever possible, upgrade Coaxial Cable, Connectors, Splitters and Amplifiers to ensure compliance to the latest specifications and formats.
