From 2-3/8" to 4-1/2 inch OD Pipe to Pipe, Pole or Tower 90° Crossover Plate Only 3S-SCX4
3 Star Inc
This 3S-SCX4 Heavy Duty Pipe to Pipe, Pole or Tower Perpendicular Cross-over Clamp Plate is used to mount from a 2-3/8" to 4-1/2" inch OD Pipe or Antenna Mast Pole at 90 degrees to another 2-3/8" to 4-1/2" inch OD Pipe, Tube or Round Tower member component via Hot Dip Galvanized (HDG) U-Bolts (Not Included), clamping to this 3/8" inch thick, 7.00 x 8.75 inch HDG 3S-SCX4 Crossover Plate. This Mounting Plate is only one of the components of the 3S-2030, 3S-2040 and 3S-2530 Kits typically used in the mounting of Conduit on a Tower, Building or Roof, as well as Antenna(s) (TV, Wireless Internet, Cellular Gateway, MIMO, DBS, Satellite, Microwave, Panel, Dish and Array) usually attached to other Masts and Pipe, Tower legs, Railings, Balconies, Roof Tops, etc.
Includes (1) Plate Only. U-bolts, Pipe, Mast Tubes and associated Hardware are Not included but are Available Separately.
Refer to "Specification" Tab above for More Detailed Information.
DownloadPipe to Pipe or Mast Pole to Tower Leg Crossover Clamp Sets and 90° Perpendicular Mounts
Crossover Mounts accommodating 2-3/8" OD through 4-1/2" OD Mast Tube Pipe are HDG (Hot Dipped Galvanized).
Crossover Mounts accommodating 1.00" OD through 2.25" OD Mast Tube are of a Pre-Galvanized Plated Finish.
All are used to Fixate and Hold (2) poles to cross perpendicularly, one to the other, preferably from an integral Structure Member to another, or even Freestanding. An Example would be attaching a Vertical Mast Pole Tube to an existing Horizontal Welded Guard Rail at two levels (Top and Mid rail) utilizing (2) Crossovers as to maintain a Cantilever against Weight and Wind Loading on the Mast being installed.
If You need to attach a Vertically Running Mast Pole to the Vertical Post, please refer to the "Pole to Pole Mount" Category in this section!
You can increase the amount of strength and holding power by utilizing multiple mounts space out over the length of the Mounting Pipe. There are many reasons you might need to use these mounts and they mostly involve the need to attach a pole to another pole to either extend the original or simply as an attachment point for prime placement location.
Both Pole to Pole and Crossover Mounts are designed to support most WiFi , PCS, Cellular, SCADA, TV and Other Light to Midweight antennas. Consult a Structural Engineer if meeting Wind Speed survivability ratings is necessary.
All of Our Mounts in this Category can easily be shipped UPS, depending on QTY Dimensional Weight.
