ROHN
Made in the USA!
This 5 Foot (60") by 1.25" OD 16 AWG Medium to Heavy Duty Antenna Mast tube is Hot Dip Galvanized (HDG) for Extreme Weather Resistance and adds a layer of zinc in the process which may make fitment difficult with other pre-galvanized (Non-HDG) Swaged-end Masts. If you are Looking to increase height by multiples of 5 foot using HDG 16 AWG masts, we recommend that you use the ROHN 5-16S Swaged-end HDG Masts solely, which are notched on the receiving end in addition to being swaged on the other for stacked fitment with another swaged section.
Be Sure and afford yourself 2 feet minimum, up to 1/3 of the overall mast length between the two wall mounts you would utilize in your TV antenna Installation. The Torque applied from wind load through cantilever to these mounts can be significant.
Manufacturers recommend that mast heights of 10 feet and higher be guyed.
(Mount Not Included)
The SSV self-supporting tower sections use angle steel cross bracing with lighter upper sections using a Zig-Zag brace pattern. The SSV tower sections can be combined with “K” braced SSMW self-supporting tower sections for added height and strength when needed.
Time tested strength and design, the ROHN SSV series of self-supporting towers provide an excellent strength to cost ratio proven by years of use. In production for nearly years in our tower design and tower manufacturing facilities, the SSV tower has evolved into a highly efficient and wide ranging system of custom towers produced from pre-engineered sections. The ROHN SSV tower is the quality standard in the industry for small to mid range self-supporting towers.
ROHN SSV towers are in use world-wide for:
ROHN SSV towers are available with a wide variety of pre-designed accessories including: