BNC Male to Cable Screw On Connector
NIPPON NF-34 BNC Male to Cable Screw On Transition Connector
This is plated with an anti-corrosive finish, Commercial Grade and Quality. The BNC connector is used for RF signal connections, for analog and Serial Digital Interface video signals, amateur radio antenna connections, aviation electronics (avionics) and many other types of electronic test equipment. The Screw-on connection is made for RG58 solid center conductor in a temporary scenario and cannot be relied upon as a permanant usage connector as wear and usage will break down the physical connection between the soft raw cable components and the connector.
Technicians will use this adapter to transition from Antenna, Cable TV and Satellite Feeds to Test Equipment Leads without needing Specialty Prep and Crimp/Compression Tools normally required for affixing a BNC to cable end.
Compare to Amphenol RF-BNC Connector Series
This is plated with an anti-corrosive finish, Commercial Grade and Quality. The BNC connector is used for RF signal connections, for analog and Serial Digital Interface video signals, amateur radio antenna connections, aviation electronics (avionics) and many other types of electronic test equipment. The Screw-on connection is made for RG58 solid center conductor in a temporary scenario and cannot be relied upon as a permanant usage connector as wear and usage will break down the physical connection between the soft raw cable components and the connector.
Technicians will use this adapter to transition from Antenna, Cable TV and Satellite Feeds to Test Equipment Leads without needing Specialty Prep and Crimp/Compression Tools normally required for affixing a BNC to cable end.
Compare to Amphenol RF-BNC Connector Series
An adapter (or adaptor) is a device used to match the physical or electrical characteristics of two different Connectors so that a connection may be made between them and the Equipment You desire to Cross-Connect. Most Connections for Video and RF (Radio Frequency) Equipment is 75 Ohm in Characteristic Impedance. Radio and Microwave Frequency Connections Passing High Power Require 50 Ohms. A Majority of the Adapters offered Here are 75 Ohm. However, with the High Quality Dialectric Found Surrounding the Interior of the Mating Connection, Low Power Usage, and Transition Impedance Matching of Like Characteristic Impedances, Resulting Mis-match of 50 Ohm use woiuld be so Low as to be Considered Negligible.
Live Support
Sorry, we are offline,
click here to send us message
