EVO1-SP-4 Cable TV Antenna 4-Port Coaxial Splitter
Engineered with reliability and functionality in mind Evolution’s digital splitters deliver superb RF performance for today’s evolving cable networks. With quality as our primary objective, 100% of our splitters are QC tested at the factory prior to being shipped. Our UL Listed splitters are specially designed with raised bodies to provide more room for the installation of connectors and to allow moisture to pass behind the splitter instead of trapping moisture on the back plate. The unique manufacturing process used to make our digital splitters eliminates parting lines on the splitters ports, which are a source of moisture migration. Patented, enhanced conical seizure mechanisms are used in all splitters to maximize contact surface and center conductor retention. The zinc die cast housings and back plates are plated using a proprietary multilayer nickel plating process that offers excellent corrosion protection. All back plates are soldered to ensure a hermetical seal and RFI isolation. .
Spec. Sheet
4-Way Splitters are typically the Part you would use to take One (1) cable Feed and "Split" it into Four (4) in order to Provide Signal to 4 Independant Devices, or Three More Cables to complete the Run(s) to their Final Destination(s). Please be Sure to Select the Appropriate Splitter not just By Manufacturer and Price. But Rather, Consider the Specifics of Bandwidth, Packaging (Indoor vs. Outdoor), Loss, Powering Requirements Up/Down-Stream and the Overall Needs of the Final System You Wish to Create...
If you are adding a splitter to an existing Cable TV or Antenna feed, you may need to compensate for the loss that you are about to introduce. The gain of a Line Amplifier should be selected to zero out the loss that follows it. In other words, if you have fifty feet of cable and a two-way splitter, then a 10 db amplifier will be fine. Conversely, if you have an eight-way splitter and hundreds of feet of cable, you will need an amplifier with a higher gain. Just as in the case of a Pre-Amplifier, however, bigger is not always better.
Commensurate with Coaxial Cable TV Antenna Splitter Installation, you want to Ground your Cable TV or HDTV Antenna Coaxial Cable System Outside before bringing the TV Cable Inside. This way, Lightning Strikes and Power Surges have an opportunity to arrest before reaching your TV and Entertainment Electronics. The Integral Grounding Block designed onto every Outdoor Use Compatible RF Signal Splitter we sell will effectively convey this unwanted Electrical Energy to a Ground Rod via a Copper Ground Wire that you Install (not included). Consult your Local Building Code and NEC for guidance to Properly Grounding your HD TV Antenna, Cable TV, WI-FI, Wireless Internet, Business Band, CB or Amateur Radio Antenna Installation.
Sorry, we are offline,
click here to send us message
