3 Star Inc.
Made in the USA!
Ideal for Light Off-Air TV, Satellite Dish and Wireless Internet Antenna mounting, is constructed of pre-galvanized steel, uses 6 standard concrete blocks as Ballast, 28.5 x 35.5" base.
This size mast is a Standard for simple, single Satellite TVRO (TV Reception Only) and DBS (Direct Broadcast Satellite) Dishes less than 1.5 sq. ft. in Surface area. Most TV and Radio Reception antennas have U-bolt mounting that can accommodate up to this diameter as well. This is akin to most "J Pipe" Eave mounts for similar purposes. Non-Penetrating Roof Mounts can be utilized within various weight restrictions depending on the Structural Composition of your flat roof, and when set up on a Rubber Mat or Pad, will protect surfaces such as Shingle and Tar, Pea gravel, Membrane and bare concrete without puncturing or marring and help distribute the weight evenly.
These mounts can be used where penetrating its attachment is not an option. Non penetrating mounts use ballast weight like your usual cement cinder block as a method to hold down your masting structure. They can help meet the variety of communication tower needs such as Cellular, PCS, Wireless Cable, Microwave, Wireless Internet, WiFi Hot Spots, DBS, MDS, MMDS and UHF/VHF reception.
Designed and engineered to handle the job of getting above ground interference, each non-penetrating roof mount has been researched and developed to serve a specific purpose.
With professionally engineered construction, you can be assured you're getting a virtually maintenance-free product built to the highest standards. And because our non-penetrating roof mounts are hot-dip galvanized after fabrication, our mounts won't rust.