Easy Up EZ32B Base Plate for Telescopic Pole and Antenna Mast Ground Mount
Easy Up
Made in the USA!
This Easy Up EZ32B Galvanized 7.5x4.5 inch 16 gauge Base Plate and Pier pin style Stake is for Ground Level Elevation installation of Telescopic and ANY Antenna Mast Poles from 1.25 to 2.25 inch Outside Diameter in Permanent Base Mounting by placement upon a Concrete Foundation with the Center Stake inserted into, and the Plate resting on top of, a (1) Foot Cubed bed of gravel or pad of Poured Concrete above surrounding soil elevation.(depending on soil and frost conditions) The Pier Pin Style Center Stake Rod is approximately 1" in OD and floats freely within the Mast Tube placed over it and is not fixated other than by the Down Guys installed to secure the mast from wind-load.
Will Also Accommodate Telescopic Masts:
ROHN H20 H30 H40 H50 and Easy Up TM-20 TM-30 TM-40 TM-50
Manufacturers recommend that masts heights of 10 feet and higher above the uppermost bracket be guyed for Addition Wind Load Support. Bonding/Grounding should be made by affixment to Mast. Consult NEC and Applicable Local Code for further guidance
This Base Plate can be used with ROHN H30, H40, H50 and Channel Master 1620, 1630, 1640, 1650, 1820, 1830, 1840, 1850 Telescopic (Push-up) Mast. You could also use this as a base plate for 2 inch or 1 and 1/4 inch O.D. Masts. This Plate can be cemented into the concrete Pad via the Pin provided. The word "Ground" as used in the description can be a bit of a misnomer; it does not provide a "Earth Ground" in and of itself, but rather is a junction component that rests on the ground or pad and should be Bonded to with a proper Earth Ground composed of a 5/8 inch by 8 foot Copper Clad Ground Rod as a minimum. Consult your Local Building Code and NEC for guidance to Properly Grounding your HD TV, WI-FI, Wireless Internet, Business Band, CB or Amateur Radio Antenna Installation.
RG6/U General Utility Use 95% Copper Braided Shield
When 95% braid coverage is noted, usually the purpose of the cable can be inferred as CCTV Camera Video Cable. CCTV Camera Video Cable is usually RG59. That this is RG6 with 95% Braid Coverage, and further, comprised of Solid Bare Copper in the composition of the Center Conductor, makes it rarer still. This cable will perform in both CCTV Camera Video and Satellite TV worlds with the Best Traits of both.
