Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools
Your Cart
Your shopping cart is empty!
Printer View Tell a Friend

Heavy Duty Antenna Pipe to Pipe Mount 4" to 9" OD

Manufacturer Code3S-40-16
AvailabilityUsually ships in 24 Hrs
ShippingCan ship anywhere



For Pipe 4" to 9.00"

5/8" x 16" Treaded Rods

Heavy Duty

Bulk Quantities Available Here!

3S-40-16 Heavy Duty Pipe to Pipe  Mount 4" to 9" OD

Heavy duty antenna pipe to Pipe mount ideal for use on vertical or tapered tower legs . Attaches two pieces of similar sized pipes 4" OD to 9" OD , Comes with 2 x 5/8" x 16" Treaded Rods , heavy duty nuts , washers & lock washers  . Hot Dipped Galvanized  for corrosion protection .Ideal for use on Towers and Ice Bridge posts


4 - HDG 11" wide clamps 

     Pipe Range 4" to 9"
2 - 16" x 5/8" HDG  threaded  Rods
8 - HDG Hex Nuts

8 - HDG Lockwasher

8 - HDG Flat Washer

Buyers Guide
Rate this product.
Product isn't rated yet. Write a review.

The Pole to Pole & Crossover mounts are designed to support most WiFi , PCS, Cellular, and TV antennas. The Pole to Pole Mounts allows you to vary the mounting pipe length and diameter, 

All of our mounts are weather protected using either a HDG (Hot Dipped Galvanized) or a Pre-Galvanization finishing process for corrosion protection.

The pole to pole mounts allow you to connect one pole or mast to an adjacent pole or mast of the same or of varying diameter. 

You can increase the amount of strength and holding power by utilizing multiple mounts space out over the length of the mounting pipe. There are many reasons you might need to use these mounts and they mostly involve the need to attach a pole to another pole to either extend the original or simply as an attachment point. 

All of our pole to pole mounts can easily be shipped UPS.

Products   Recently Viewed