Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools
Your Cart
Your shopping cart is empty!
Printer View Tell a Friend

Non-Penetrating Roof Mount with 2.375" O.D. by 30" Mast

Price$112.00
Manufacturer Code3S-FRM-238-30
Qty
AvailabilityUsually ships in 24 Hrs

Highlights

30" Mast HDG
2.375" O.D.
DirecWAY
StarBand
Comes with Hardware

Bulk Quantities Available Here!

3S FRM-238-30 Non-Penetrating Roof Mount with 2.375" O.D. HDG  Mast 30" in Length


is constructed of 11 Ga steel and uses standard concrete blocks to anchor to Flat Roof. This Pr-Galvanized Finished Non-penetrating Roof Mount Base allows you to install dish antennas on flat roofs where no holes can be drilled. The heavy steel base is 34-3/4" square. Pre-Galvanized Finish helps against corrosin protection . Steel Mast is 2.375 inches in Outside Diameter and 30 inches in Height from Base. Perfect for use with DirecWAY and StarBand systems. Can be Used as a Penetrating Mount without Ballast when Field Drilled to use optional Pitch Pad Kit. Compares to Other Name Brand Hardware at Half the Price.
 

 

The HDG 2.375, 2.38, 2-3/8 inch Diameter Pipe size mounts HughesNet, DirecWAY and STARBAND Satellite Internet Dish Antenna, PR-TV and some SCALA UHF Antenna, Andrew, Gabriel and Blonder Tongue Microwave Parabolic Reflector Antennas. And with a little Field Drilling, Screws and Pitch Pads are available as an option for Bolt-down versus Ballast applications. The Length of the mast is 30 inches based on engineering that incorporates consideration for typical Dish Antenna Wind-load versus the Ballast that would keep either on target with minimal deviation and flex. As with all Ballast mounts, Structural Engineering consultations are recommended for all Roof Applications.

Buyers Guide
Spec Sheet

Flat Roof Non-Penetrating Mounts

These mounts can be used where penetrating its attachment is not an option. Non penetrating mounts use a balasest like your usual cement cinder block as a method to hold down your masting structure. They can help meet the variety of communication tower needs such as Cellular, PCS, Wireless Cable, Microwave, Wireless Internet, WiFi Hot Spots, DBS, MDS, MMDS and UHF/VHF reception.

Designed and engineered to handle the job of getting above ground interference, each non-penetrating roof mount has been researched and developed to serve a specific purpose.

With professionally engineered construction, you can be assured you're getting a virtually maintenance-free product built to the highest standards. And because our non-penetrating roof mounts are hot-dip galvanized after fabrication, our mounts won't rust.

  • Additional Features Include
  • Offer both Fixed Mounts and Ballast Roof Mounts
  • Pre-Galvanized for corrosion protection
  • Varied mast heights available
  • Varied mast pipe O.D. available
  • Quickly shipped and quickly assembled
  • Minimum bolted connections
  • Engineering ballast tables available
  • Optional roof pads and mats available
  • All models are UPS shippable

Products   Recently Viewed