ROHN WM4 Antenna Wall Mount 4 inch W Style Brackets for 1.25 to 2.75" OD Mast
ROHN
Made in the USA!
The ROHN WM4 is Galvanized 14 Gauge Steel Bracket Set of (2) Heavy Duty "W" Style Brackets with Anti-Twist Feature and Hardware Included for a 4 inch Standoff Wall Support of Light and Medium Duty Antennas on Mast Poles from 5 to 10 feet long and from 1.25 to 2.75 inches in Outside Diameter including Telescopic Antenna Mast Poles for Off-air and OTA TV, UHF/VHF Radio, Remote Telemetry Control and Monitoring Stations, Cellular Date Gateways, WiFi, Wireless Internet, Receivers, Boosters and Repeaters.(Mast Not Included)
These mast mountings are typical and generally require the cantilever distance between the mounts be one quarter (1/4) to one third (1/3) of the mast length depending on Wind Load, starting from the bottom with 2 foot between brackets being a minimum distance. All Masts greater than ten feet in length, and/or 2 inches or greater in O.D. should be based upon and from the ground in rising up to the desired height.
Also for Telescopic Mast Poles comprised of 1.25", 1.50", 1.75", 2.00" and 2.25" Tubes nested together and then extended, these wall mounts can supplement structural support but are not designed to take the place of a Base in Supporting the weight of the Mast off the ground or guying. Be sure and check that the Tube segments you wish to wall mount will fit within the Outside Diameter Window specified that the Brackets will accommodate. Set screw installation may require some field drilling.
Manufacturers recommend that ALL masts above 10 feet from their uppermost support be Guyed
With more height in your installation, Grounding/Bonding is a recommended consideration.
In-line Drop Cable TV Bandpass Filters
Filters that are typically Notch (Channel Removal), Band Pass (Pass Specific Range) or Pass Band (Pass all BUT a Specific Range). If Installing a Filter that will affect an entire Network, it is best to install at Amplifier Input versus Output. Notch Filters are part of but not completely effectual alone for Channel Elimination. Common Band Pass and Pass Band Filter examples are Diplexers and Separators. Very Few Filters handle Voltage Pass, be Careful to ascertain their Capability prior to Use.
