ROHN 502 Porcelain Strain Insulator up to 3/8" Strand Down Guy
ROHN
The ROHN 502 is a Porcelain Strain Insulator rated at 10,000 lbs. Ultimate Strength with a 5,000 lbs. Working Load Limit (WLL) for up to 3/8" inch strand. It has 5/8" holes for Clevis and Preformed Dead-end Termination Down Guy Segments with a 3-1/2" length and a diameter of 2-1/2". Guy Line Insulators are used to isolate RF (Radio Frequency) Electrical Conductivity and Passive Re-Transmission or Intermodulation by dividing guy wires into non-resonant sections. This prevents the guy lines from altering an Antenna's Radiation Pattern due to near-field interaction and for Ghosting Resonate Towers to Prevent Shadow Zones of other Transmitter Facilities Broadcast Coverage Area. A compression-type design is used and the insulator is compressed within the wire loops, so that if the insulator should break, the guy wires are still attached.
Antenna Guy Wire for Guyed Towers & Telescopic Masts
3 Star Stocks EHS 7 Strand Guy Wire for use on ROHN 25G, 45G, 55G and 65G Guyed Towers Systems as well as Utility OSP Cabled and Fiber Systems. Our EHS Tower Guy wire comes in 100', 250', 500',1000, in coils or reels and 5000 FT wooden spools. PLP-GWD Guy wire Dispenser available (optional). It is recommended that "Initial Tension" (10% of Maximum Limit) is attained with the Turnbuckle travel extended prior to tensioning with same. Annex the Data shown in the Table below when referencing guy charts shown for ROHN Towers:
Our 6/18 (6 strand 18AWG) and 6/20 (6 strand 20AWG with or with out Plastic Coating) guy wire comes in lengths of 50', 100', 250', 500' up to 1000' FT. Choose from 6/18 and 6/20 for Guying Telescopic Antenna Masts. Also, Complete Telescopic Guy Wire Kits are also available.
